Questions & Answers for: Toyota Land Cruiser remove gearbox

...the gear lever at P positon , the remove the selector cable from the gearbox then push the selector mechanism til that it wont move, fit the cable back then try it out ....hope that it will ...

...gearbox worsens when hot. remove the carpet on the floor, remove the gear shift lever as well as the 4wd shift lever, remove the drive shaft (both) remove the bell housing bolts, remove the starter, ...

gearbox oil on a landcruiser hj75 1985? thanx in advance! Look on either side of the gear box and about half way up you will see a big bolt head.remove it and pump oil in it till it starts running out

...remove the speedometer cable from the top of the transmission. And use the hole from that to ad fluid and the speedometer cable worked as a dip stick. Hope this helps. Wrong, the hose is take the oil ...

...gearbox or does the engine need to come out? Motor out is not needed. You need to disconnect the drive shafts, put a jack under the back of the motor, and put a trolley jack under the box before you ...

...the engine has gone wrong. I cannot get an engine in the uk, can the original 5 cylinder be removed and a 6 cylinder be bolted in to the same manual gearbox? The engine is diesel. hi mate i ...

gearbox ecu storing faults ,need to clear them on some vehicles you remove the neg batt. cable for 15 seconds, then reconnect to clear fault codes,get more input to be sure

I have an 80 series petrol Landcruiser which requires clutch replacement. When removing gearbox I cannot move gearbox back far enough (fouls on transmission tunnel) for input shaft to clear pressure ...

key stuck in ignition Key will not come out of ignition when in park position on gearbox Your ignition is probable locked up you could replace ignition by removing steering wheel.

central locking not operational batteries removed when having gearbox upgraded. central light, radio and central locking now not working Check fuses if bolwn replace them with same Amp rating, if none