Questions & Answers for: remove gearbox


...gearbox worsens when hot. remove the carpet on the floor, remove the gear shift lever as well as the 4wd shift lever, remove the drive shaft (both) remove the bell housing bolts, remove the starter, ...


...remove a gearbox from a 2004 mini can i remove a gearbox from a mini 2004 model without taking out the engine. I don't believe you are able to remove just the transmission , you may have to remove ...


Question about 2006 504

1 Answer

...206 GEARBOX, WHICH IS THE EASIEST WAY TO DO IT disconnect lower arms, and remove driveshafts..disconnect all wiring and remove bolts from gearbox bellhousing and remove gearbox from underneath the ...

...remove the gearbox from a 1999 suzuki swift car disconnect battery remove it & its cradle jack it up & drain gearbox oil remove the wheel & undo the axle nut in the centre! [do not remove ...

Question about 2006 Corolla

1 Answer out of the gearbox. You will have to carefully replace this seal, to do this you need to take the gearbox out of the car, put it on a bench and carefully remove the old seal and press in a new

...gearbox remove How to remove clutch and presure plate or the gearbox You need the right equipment and knowledge to do this job there are a lot of cables wires etc that need to be removed before the ...

...remove the gearbox from a hyundai atos prime automatic? remove a gearbox Support the engine, remove ball joints from the lower control arms, disconnect the tie rod ends, remove all cables and wiring ...

...gearbox. Remove the starter motor. Loosen the propshaft. Mark the yokes of the propshaft- for upon installation to avoid an unbalanced propshaft. Loosen the centre bearing. Remove the propshaft. ...

...gearbox out 1 Remove battery earth cable. 2 Remove gear shift lever - usually just pulls out. 3 Remove starter motor. 4 Remove bolts holding prop shaft to gearbox final drive, and remove the prop ...

I'm replacing the clutch. I have removed all the bolts and separated the the housing slightly but cannot totally separate the two. I'm thinking I may be missing a step. in the same area of the bolt ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

23438 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides