Questions & Answers for: Oldsmobile Intrigue remove door

Question about 1998 Intrigue

1 Answer

Remove the door handle bezel. Remove the door trim panel screw located behind the door handle bezel. Remove the door trim panel screws located by the armrest handle. Remove the door trim panel using J

Ad

remove door panels and replace window regulator on an Intrigue?Answer : For a 2002 Intrigue ? Front Passenger I didn?t disconnect battery. You use window switch later to align window tabs to regulator

Ad

where is the door lock located inside drivers door? yes it is inside the drivers door, you must remove the door panel to access it.

...door lock switch in the unlock position, insert and remove the ignition key twice. Do not rotate the ignition lock cylinder. 6. Insert the ignition key a third time leaving the key in the ignition ...

...Remove the door latch trim plate (coupe and sedan front doors). 2. Remove the ashtray (sedan rear doors). 3. Remove the seat belt retractor cover (coupe and sedan front doors). Use a suitable door ...

...remove the inside front door panel? There are two screws in the arm rest that you will have to remove. Not sure if there is one by the mirror on Intrigue. But the rest of the door panel is held on by ...

...remove the right rear door panel on my 2000 Intrigue and need some preliminary instructions so I don't cause damage while removing it. Chuck Hickman should be similar to my 2000 camaro, which I show ...

...remove the interior door panel to replace the driver's side electric mirror? If so, how is the interior door panel removed? You have screws in the panel that have to be taken out first. how many ...

Question about 1999 Intrigue

1 Answer

...door You will need to remove or unplug the wiring harness,remove the bolt or roll pin on the door check(keeps door open or from opening too far)then remove bolts where the door meets the hinge.You ...

Question about 2002 Intrigue

1 Answer

how do you remove door pins take a flat head screw driver place at top of door pin tap upward with a hammer or take a small phillip screw driver place at bottom of door pin and tap out with a hammer.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...