...purge valve, start checking the vacuum hoses and lines all the way back to the EVAP canister near the gas tank. Make sure no hose or lines are cracked / disconnected. If all looks OK, let me know and ...
...on the breather line to the fuel tank,if the cap is not tight it can't create vacume.and will fail the test.The second would be a cap replacement,The third would be a purge valve or line
...purge valve, but cant rule out the rest...however the purge is a real easy test done in your hand.... pull the vac. hoses off it and shake it...if gas comes out of it the purge is defective and needs ...
...purge valve. The vent equalizes pressure between the tank and the atmposphere. The Engine controller closes the vent valve during certain tests. On the tank somewhere there is a wein bridge type ...
...purge valve on top of the engine as shown below (#1 in picture). Make sure the electrical connector is on the valve, that the wires are not damaged, and check the hose for kinks. If all looks good, I ...
...Purge Valve Stuck Open Daewoo: CANISTER V/V OPEN / SHORT Ford: Purge Valve Stuck Open Honda: IMA System Problem Hyundai: EVAP System Vent Solenoid Circuit Infinity: EVAP Control System (Small Leak) ...
...Purge Solenoid Valve (CPV). It accomplishes this by grounding and un-grounding the control circuit to the CPV. When the CPV is open, engine vacuum is applied to the EVAP canister and ultimately, the ...
Question about 2007 Trailblazer
...valve purge port. Disconnect the EVAP canister purge solenoid valve harness connector. Monitor vacuum on the vacuum gage. Start the engine and allow the engine to idle. Increase the idle to ...
Question about 2006 TrailBlazer LS
three codes p0496,purge valve replace still have a p0.496 the a p0506 cleaned throttle body,and now a p0171 i cleaned the throttle body replced purge solenoid Go to www.obd-codes.com and look these up
Question about 2003 TrailBlazer
purge valve/control solenoid and still same problem Testing the system an not replacing parts is the way to find the problem . Without knowing how ,using a factory diagnostic flow chart to go by would
Usually answered in minutes!
3,219 Questions
2,541 Questions
1,576 Questions
1,050 Questions
976 Questions