20 Most Recent 2006 Chevrolet Trailblazer Questions & Answers


Could be that the potentiometer is not tracking properly. If that is not it, then it is the chip that controls the volume at fault.

2006 Chevrolet... | Answered on Dec 18, 2019


Before you go running down the rabbit hole, i.e. reprogramming key fobs, replacing the Lift Gate Module, removing body panels looking for broken wires; do two things:
1.) Open every door and slam it shut.
2.) Almost every auto parts store has a key fob test station, verify the key fob is transmitting.
Those two simple steps will solve it most of the time. If not... I hope you like carrots.

2006 Chevrolet... | Answered on Oct 25, 2019


The code indicates an issue with the Throttle Actuator control. This is a little motor on the throttle body that opens the throttle plates at idle. That control motor may be bad and thus, causing a low idle.

I hope this helps.

2006 Chevrolet... | Answered on Oct 11, 2019


In the centre of the dash, just below the radio are two round knobs. Left side is fan speed. Turn that to 5. Right side turn all the way to the right for defrost. At this point, if the air isn't blowing out the top of the dash onto the windshield, you have a problem. This video may help.
https://youtu.be/xazoup8tUQM
Hope this helps.
Good luck

2006 Chevrolet... | Answered on Jul 30, 2019


Change Engine Oil Light = wrench with a car next to it
StabiliTrak® Service Light =
car skidding in a triangle.
This light will come on if a problem is detected in the StabiliTrak® system

2006 Chevrolet... | Answered on Jan 30, 2019


5.3L engine, #8 in the picture, probably just a press fit into rubber grommet. After you get the hose off, hopefully it just pulls out.
pcv-diasfbtz1mhjh2klbprmsoqe-3-0.jpg

2006 Chevrolet... | Answered on Nov 07, 2018


It's easy, you'll want to get Novita LM486 flasher, that way you can run LED's with no problems if you ever choose to do so. It's right under the steer wheel. The panel your knee hits, remove it, it's laying on it. About 4 inches long, about an inch wide. It's a big one. Novita manufacturers all of GM's flashers, the LM486 is LED compatible, will work with or without LED's. Orielly's has them if you need one quick.

2006 Chevrolet... | Answered on Jul 17, 2018


My friend is a part time mechanic he gets his solutions from www.reliable-store.com
he gets from their every single detailed info, instructions etc. on all vehicles, and manuals like service, repairs, parts, owner's, operations, maintenance etc.
U can get help from there
there is a girl at chat she can help you

2006 Chevrolet... | Answered on Jul 06, 2018


You should go to www.reliable-store.com they have got books on every vehicle and also how to service/repair it, parts info, fuse box, gear box, torque specs,coiling, wiring diagrams, electrical diagrams, fuse diagrams, error codes, etc everything

2006 Chevrolet... | Answered on Mar 15, 2018


check the wires at the door hinge and the connection for the door under the dash

If you need further help, I’m available over the phone at https://www.6ya.com/expert/david_4c166ba81493f541

2006 Chevrolet... | Answered on Feb 22, 2018


You got a jump and it ran fine? It's your battery. The lights and radio are much easier for a battery to handle than spinning a car engine. Again, if all you needed was a jump, you have a bad battery.

2006 Chevrolet... | Answered on Jan 20, 2018


Take it to a qualified repair shop.

2006 Chevrolet... | Answered on Dec 03, 2017


There is no fuse marked for dome light's in the rear fuse box. The BCM - body control module controls the dome / courtesy light's .
The body control module (BCM) monitors the courtesy lamp switch signal circuit in order to determine when the courtesy/dome lamps should be illuminated. When the BCM senses that the courtesy lamp switch signal circuit is grounded when the switch is activated, the BCM will directly illuminate the courtesy/dome lamps.
DTC B3801 Passenger Compartment Lamp Request Circuit

You should possibly think about taking your vehicle to a qualified repair shop !
Install a scan tool.
Turn ON the ignition, with the engine OFF.
With a scan tool, observe the courtesy lamp switch parameter in the body control module (BCM) data list.
Does the scan tool display INACTIVE?
YES - Go to Step 3
NO - Go to Step 4
3
Activate the courtesy lamp switch.
With the scan tool, observe the courtesy lamp switch data parameter.
Does the courtesy lamp switch data parameter change state?

• Test the courtesy lamp switch for sticking in the ON position.
• Perform a visual inspection for loose or poor connections at all related components. Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems.

2006 Chevrolet... | Answered on Nov 24, 2017


Have the vehicle check for DTC'S diagnostic trouble code's . Qualified repair shop !

2006 Chevrolet... | Answered on Nov 03, 2017

Not finding what you are looking for?
2006 Chevrolet Trailblazer Logo

1,624 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

TrailBlazer Chevrolet

  • TrailBlazer Chevrolet

Most Popular Question

defrost control 2006 chevy trailblazer v

  • Cars & Trucks
Loading...