machine acting up, and if I lift and lower the lid it spins. Sometimes I have to do this more than once to get it to spin. What part is needing replacement? Popcorn, sounds like you are having trouble
...popcorn causes the sensor to shut the machine down. I would imagine this would be the same for a baked potato. Very poor design. I was told to put a microwave safe plate down and put the popcorn bag ...
...popcorn machine, how hard could it be? Make sure the stirring bar it tight on it's shaft, make sure the plastic bolt is tight. Add about 2 tablespoons of vegetable oil, and 1/4 to 1/3 cup popcorn ...
...machine had been working fine. Suddenly it began leaving alot of unpopped kernels. Seems to pop half a batch and then stop. The problem you are having is the thermostat inside the kettle is getting ...
...machine and wait til it stops popping. I LOVE my new pop corn popper. I will not do the hot air one again. I always had kernels flying all over my kitchen and popped popcorn everywhere, The Cuisinart ...
...popcorn machine wont heat up I have a real popcorn popper, and the heater suddenly stopped working! What should i do? First, if you have another cord like this one (for example, a coffee pot cord) ...
Question about 2102E Deluxe Citation Popcorn Maker
...popcorn maker from the top with the bass tools then trace down the wire to the propeller (tuning device) to see if the disconnected wire then try to fix it back to it position but if there is no sign ...
...machine just 'dead'? Help please! Would love to actually have popcorn for snack! your problem is in the instructions.. you need to make it a little hot, means run it on empty for a few min. ...
popcorn machine 8oz stirring rod please? My 8oz popcorn machine stopped working, i was told the 60ktyz motor is burnt, so i was told to change the motor but the stirring rod was stock into the motor .
Question about 2131 Antique Gay 90s Pinto Pop Popcorn Maker
popcorn machine parts, but the stick that extends from the popcorn kettle (stir rod I think) won't turn. The gear on the top of the machine seems like it's stationary, and the gears are trying to turn
Usually answered in minutes!
378 Questions
257 Questions
252 Questions
238 Questions
190 Questions
