Question about DVD-937 5.1 Channel DVD Player/Receiver Home Theater Speaker System System
...dvd player disk is stuck in the player and the door will not open. What should I do. hit it Open the cabinet by removing all eight screws, locate the two screws holding down the top of the dvd drive ...
...Open the DVD tray 2. Press STOP button on the remote control 3. Press 70 4. Press MENU 5. Use the numeric keypad to select your region code number (0 ? 6). OR DVD224 (224SS) 1. Open the DVD tray 2. ...
...dvd player lid and slowly pushed the laser head away from the center until it was under the outside edge with only the edge of it visible to you. Then with a finger nail pull it back out about half ...
...dvd player, reinserted the movie, and the play symbol, just went around and around. The remote works, because it opens and closes. I tried another movie, one I new was brand new, and it did the same ...
Question about TF-DVD7100 Portable DVD Player
...DVD player it says that it is open and wont read the disk, can you help The lid closure interlock is not satisfied; it's located to the left of the open button (a tab on the top lid should hit the ...
...DVD-224 player that won't open to put disk in I can't get it to open to put the disk in. help? Is this a $30 DVD player? How old is it? Either take it back from whence you purchased it for a ...
...open button on the DVD player, it does not open. I can manually open the door, but the DVD tray does not come out. Check to see if anythig is blocking the tray from opening. Also the tray motor or ...
...open the dvd player, push down barely, not enough to close but just enough to get it spinning. About 10 seconds later, the movie popped up. Again, if you push down to hard it will close and read no ...
...dvd won't open up when the open/close my coby-514 dvd player won't when the open/cloe button is pushed. disc is stuck, remove cover screws and carefully remove the disc, do not force the unit, once ...
...dvd player open it up then remove the face, it should have two screws on each side.after you have done that look under the dc draw you will see a gear spin it counter clock wise then the tray will ...
Usually answered in minutes!
515 Questions
466 Questions
286 Questions
180 Questions
217 Questions