...Basically the manual says to check the ribbon cables inside the scanner and the shafts that the motor runs
...get the same error eventually is this normal? These error codes indicate a problem with the mirror motor circuit in the printhead assembly or the mirror motor cable to the system board cable or ...
...be on the network card Hi. I have a T632 printer. I have the same problem. Frozen on normal node (motor not running at all); When I turn it on while pressing the select/ back buttons to enter into ...
...in this printer can depict 2 things:--- The Hsync Signal of the Printer has failed. The Mirror Motor Unit of the Printer Head has failed or not working. Check both the points and take
...even power on. Can you advise what you think the problem may be do this disconnect the scanner motor plug from the engine board this plug is at the top of the engine board it will be either all ...
...shield mounting screw (B) from the main drive motor assembly. 5. Remove the engine board. Note: Anytime the engine board is replaced, the Configuration ID must be reset in NVRAM on the new engine ...
Error message service dc pick motor on screen Roller spins but doesn't pick up paper Get new rollers. They are held on with a little clip you push in and the wheel slides right off
repeatative gost images Main drive motor may be failing
erreur 933.00 printed erreur Error indicates that the mirror motor is locked, no first HSYNC received... which means no information was received from the printhead. * Check printhead * Check cables ...
paper keeps jamming up and has error code 201.34 It's possible that the motor gear is not turning. Check the voltages at J20 on the system board. If the voltage is incorrect, replace the FRUs in the ...
Usually answered in minutes!
139 Questions
129 Questions
130 Questions
122 Questions
152 Questions