...hole thru the microwave face and the hinge bracket if there isn't one on your model. This should be fixed to prevent microwave leaking out. If you can not find a screw at a local ...
microwave could be dangerous. 2) The antenna cap usually has a small hole in the centre, but if there are any other holes in it the magnetron itself could be damaged, and holes caused by the magnetrin
Question about R-820B Convection/Microwave Oven
...microwave vent hole? I had a similar problem, it didn't matter since most of the new over the stove microwaves can vent back into the house as an option. The hood should have been a 30 inch and the ...
hole in the face of the microwave that appears to be for a screw. However, after reading on the internet from people with the same problem - it seems that this hinge is tac welded on the inside of the
...bottom of the top cabinet to the cooking surface of the stove to provide enough clearance for the microwave. The top cabinet must also be at least 30 inches wide and 12 inches deep. Find someone to ...
Question about Spacemaker JVM1640SJ Microwave Oven
...that you can drill holes into the bottom of the cabinett so the holes you drill will match up with the holes in the microwave. Once done then there should be screws and fiber washers. Good luck, ...
Question about Spacemaker JVM1640SJ Microwave Oven
...bottom of the cooker. 3. Add 2 1/2 cups water. 4. Microwave on high setting 10 minutes, stirring after 5 minutes. 5. Remove from microwave, stir noodles, secure lid and lock clamps. Close vent holes. ...
...(there is a hole) between a top and bottom hole on the frame of the microwave to keep it from ever moving again. You want to pull the entire assembly (black plastic) towards the microwave
Question about PLMV169DC Microwave Oven
...hole thru the microwave face and the hinge bracket if there isn't one on your model Posted on Apr 16, 2012 note: I did upgrade the bottom 3mm rivet to the next bigger one by first drilling out the ...
Question about 30" 500 Series Over-The-Range Stainless Steel Microwave - HMV5052U
...maybe just not dropping the microwave low enough to fit in the slot at the bottom of the wall mount before you tilt the micro up.. check it one more time...including the directions before you ...
Usually answered in minutes!
3,405 Questions
567 Questions
285 Questions
308 Questions
275 Questions