Questions & Answers for: Chevrolet Blazer lock removal

Question about 1985 S-10 Blazer

1 Answer

...easy. Getting to it is a bit involved. You'll need some specialized tools. A steering wheel puller Lock plate compressor Torx drivers Metric sockets Breaker bar Marker or paint pen Patience To keep ...

Ad

...get to it.. took the steering weel off but ..? You took off the steering wheel now you are at the lock plate. this is a spring loaded plate you need a lock plate compresser to remove the thin lock ...

Ad

Question about 1987 Blazer

1 Answer

...lock cylinder removal for a 1975 blazer. this does not have the screw to remove the cylinder lock like on a 1976 blazer. turn to accessory and use straight paper clip yo pud pi inside the hole in ...

removal After you remove the fuel tank, and remove the fuel pump lock ring, it comes out, no picture needed. its cut and dry, remove fuel tank, make sure all lines are unhooked and wiring to pump asm,

removing axle from 2000 chevy blazer my manual says to remove the pinion shaft to get to the c locks on the axles, but i can't get the pinion shaft out. any tricks? unbolt set bolt than slide out of ...

Question about 1999 Blazer

1 Answer

How do you replace a lock? remove door panel remove linkage remove lock retain clip. use masking tape to cover a flat tiped screw . place tip under door panel gently ,but firmly pull out . screw in ...

my ignition is locked and will not turn. i am trying to replace the ignition but am having trouble figuring out how to remove it. do u have to take the steering wheel off and if so wont that mess up ...

Question about 2001 Blazer

1 Answer

98 Chev Blazer. power lock problem. driver's door would not unlock doors, now it will not lock doors. passenger side works fine you may just have a bad connection under the lock button under switch ...

lock cylinder. Rotate the alarm switch 1⁄4 in. turn until locked in place. Install the multi function switch if removed. CAUTION Use of screws that are too long could prevent the column from

Question about 1997 Blazer

1 Answer

power lock only the power lock and driver si wont work More than likely you have a defective power lock actuator inside the door, you will need to remove the door panel and check that the lock ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...