Questions & Answers for: JVC ic stk

...IC`s again using original Sanyo chips (STK 392-110 or STK 392-180). Make sure to use plenty of heat sink compound. Coat the entire back side of the chips. Also look to see if any of the low ohm ...

tv troubleshoot for me screen has bowing at top of pic. sides are slanted like a theater effect,station i.d colours or inmage not converging HELP PLEASE chances are that IC804 has failed. You have two

...STK IC's. When I looked for the parts there are tons of IC's what part numbers do I need? There are a number of different STK type parts. You need to look on the old ones for the part numbers. May ...

...ic's . What is the correct part number to replace with. I have STK 392-110 on the board now. The recommendation of the manufacturer is to replace the ICs with the same part number. In this case, use ...

... Is it the same as the 56 IN? STK 392-110? Do I need two or just one? You will need two STK 392-110 ICs. They are located in the front of the TV. remove the speaker grille and then the small access ...

...STK-IC in power amp.section that busted already or just a loose connection.First try to resolder the pins of STK-IC and also all component parts joint in power amplifier section if its works! if not ...

need to converge the red gun convergence ICs are STK ICs example STK392-110 they will have part number on them they are big black ICs Call Mats Electronics for Parts 1-800-628-1118

...stk ic chips and the resistors around the stk chips ,cant miss em about 2 inches big with heat sinks on them. The tv convergence function can't fix R,G,B colors lines mis alignment,colors shadows and ...

STK 412-410 ICs of jvc stk 412-101

ther is pawer(ther is led indicater ) but no glow check the power slpuy or the stk con,v ic are bad if the con,v are bad it will not tune on at all stk 392-120 or 110