Questions & Answers for: fault lights 2 and 3

...fault light on after battery flat I have a peugeot 2002 110 HDI 2 ltr. it stood for 2 weeks. Battery was flat and would not turn engine fast enough. Engine immobiliser fault light was on. Recharged ...

...fault not covered in manual. Lights 2 and 4 flashing - can't start machine. This fault not covered in manual. you can reset it by pressing the following sequence:Push. heated dry, then Normal. twice. ...

...fault #2) Replace the motor control module. Replace the motor. Fault #2 Drum Gap Cannot be Located Ensure sensor module is correctly located and clipped in. Replace the lens on the sensor module. ...

channel 2 stuck on fault. plays for about 5min then fault light comes on, so now channel 2 does'nt play when fault comes on output stages faulty

lights stay on fault codes on a volvo FH12 rear left lights and 2 marker lights staying on when ignition is off Volvo has had a lot of trouble with relays in the rear control module. Check/replace the

...2 times on my 1998 ford contour it's flashing a fault code (42). the following link is from another forum explaining the fault code. ...

...lights that come on flash 8 times and then go off. What might be the problem when this happens? You have a module problem: Evaluate your batteries. 12v Single or 24 together. Flash codes: 1. Stall ...

...Check for a reoccurrence of fault DTC. Possible Fault:-HO2 Sensor 2/1 heater failure HO2 Sensor 2/1 sensing circuit: short circuit to ground, short circuit to high voltage, open circuit ECM ...

...fault perform a key dance of   HEATED DRY - NORMAL 2 times, or HIGH TEMP - AIR DRY 2 times.   this will start a diagnostic cycle that will clear the fault. if the fault continues to return ...

...the fault. The fault codes have two numbers, these numbers are interpreted by the number of times the lights flash. ...