Questions & Answers for: Chevrolet Blazer 6 l engine missing

Question about 1995 Blazer

1 Answer

...shift hard from 1st to 2nd and has a long 2nd to 3rd, does not seem to have any slipping. also the engine seems to have a light miss in it especially on the highway, the check engine light came on ...

Ad

engine misses bad at idle often stalls, runs ok engine misses bad at idle often stalls, runs ok at speed though. Checked codes from ecm gave us code 12. Don't have a book yet so we don't know what ...

Ad

Suddenly started missing badly and backfiring at Suddenly started missing badly. Backfires at low RPM. 4.3 V6 engine could be a mass air flow sensor, or a bad fuel pump.

missing. do not keep the engine torqed this way for more thn a couple of seconds. you could damage the trans.. when you locate the missing cylinder you will need to find out why it is missing. look at

i have a 1994 s10 blazer with4.3liter engine. it has a miss. it has new plugs, pug wires, dist cap and rotor button. when you pull off spark pug wire 2, 4 and 6 the engine has a rough miss. when you ...

Question about 1999 Blazer

1 Answer

of codes that it reads. It will tell you which cylinder(s) are missing and if you have any sensors that have issues or problems. This is an invaluable tool for fixing engine misfires. Good luck to you

...engine missing o2 sensors are switches in the exhaust system the engine misfires are the engines cylinders missing. check the fuel injectors and the fuel regualtor for leaks, mine was doing the same ...

...runs good, i replaced rotor button dist. cap spark plugs,wires still has steady miss and service engine soon stays on and flashes on and off. Check engine light that flashes is misfire. Check the ...

...engine gap need to be 0.060. replace fuel filter and clean fuel injectors. missing problem also caused by weak ignition coil.vacuum leaks around intake manifold look for leaking hoses.if all is good ...

...replaced the fuel injectors still unable to locate cause of misfire. I'm guessing that your "Check Engine" or Service Engine Soon" light came on, which means that a code was set in your ECM (onboard ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...