Questions & Answers for: JBL dead speaker

Blows fuses My sub stoped working. dead, no sound, no LEDs nothing. I opened back & fuse was blown, so I replaced it. Put it together & turned it on w/ no cords connected & it makes a humming sound ...

about the same. Try it with nothing attached anywhere except the power cord. No light immediately = dead

dead JBL EON 15P-1 Fuse blows again when replaced. torroidal xtfmr. seems ok. measures 60VAC when disconnected from amp. board. speakers seem ok too. each measure approx. 4 OHMS. Any suggestions on ...

...speaker just "dead" and need to be buried? problem could be in wiring, fuse, crossover or the components can be damaged. the original JBL tweeter and 5.25" speaker are no longer available so ...

I have a jbl eon g2 and used it at 1pm and then at 4pm when I went to power it up, it was dead. I swapped out power cables and line input cables, no power light comes on at all. I looked for a fuse ...

...one is repaired 2 times now, but every time I build it in the sub and plug the speaker in the amp goes "dead" again ! Dirk at Werchter Belgium Europe i had to buy a complete amp and replace the ...

I have a jbl 515 eon no power every thing is dead the fuse is ok If you can watch the fuse kind of twitch. Most likely you have somthing shorted in your output amps. ( the ones on the heatsink ...

JBL CREATURE II soundspeakers are dead without power Our lovely goldhamster bit the cables of my beloved JBL CREATURE II. After fixing all broken cables, the subwoofer has power which I can tell by ...

...speaker won't switch on. Should I return it for a refund> I sent it back to the dealer under warranty and they said there was nothing wrong with it. When I got it back it worked once then it was ...

...speaker was making static like popping sounds,then stopped,i let it run dead so i could fully charge it and now it will not hold a charge over 30 seconds,is the battery burnt or something? ...