20 Most Recent JBL EON 15-G2 Powered DJ Speaker With EQ Speaker Questions & Answers

0helpful
4answers

Tweeter not working on 15" EON G2

I have the same problem and the same conditions.
The tweeter is good, 3.8 ohms.
Some points of solding (donuts), have bad aspect.
I resolder the power transistors to the PCB and I solve the problem.
8/20/2021 6:00:06 PM • JBL EON 15-G2... • Answered on Aug 20, 2021
0helpful
1answer

My JBL EON cuts out from time to time (usually

hi there... i have same problem and i believe the main amp (part 339555-001 EON 15 G2) have to be replaced. jbl prosound sell it for $112.80 and you need to do the job yourself, which is not too big deal but not too easy either.
i did not start yet.
please post later if you did it. thanks.good luck. joel.
11/13/2018 5:06:46 PM • JBL EON 15-G2... • Answered on Nov 13, 2018
0answers
0answers
0answers
0helpful
1answer

The woofer doesnot work and the horn is working but not as usual

First you need to verify that there is nothing wrong with your amplifier. Simply swap speakers around and see if the fault follows the faulty speaker or stays on that channel. If the speaker is at fault I would hazard a guess and say, that the woofer has burnt out and is now a high resistance. This would then increase the total impedance of the speaker circuit and make the horn speaker sound the way you described. This can be verified with an ohm meter. Total impedance should be about 4 to 8 ohms. The only real remedy is to replace the faulty speaker woofer. Sorry
3/10/2015 8:11:41 AM • JBL EON 15-G2... • Answered on Mar 10, 2015
0helpful
1answer

My jbl eon 15 g2 smell like burnt and everything works but the big speaker

The voice coil in the big speaker could have been damaged if driven to loud. See if the burnt smell is strongest near the center of the big speaker. If the voice coil is fried, you may be able to still find a replacement as there is a part number for the voice coil (V/C Assy, EON-G2220-27005-00) and the cone (EONG2 Cone Repl. C2REON15P-2)
1/20/2015 1:01:35 AM • JBL EON 15-G2... • Answered on Jan 20, 2015
0answers
0answers
0helpful
1answer

5yr old EON 15-g2 works fine for short time then goes fuzzy sounding, like woofer is blown. Turn off speaker for few minutes , turn back on speaker works fine but goes fuzzy after a few minutes. Can

I HAVE THE SAME PROBLEM. AGENTS OF LITTLE HELP. THEY TEST FOR A FEW MINUTES AND REPORT ALL IS WELL
7/26/2013 8:37:41 AM • JBL EON 15-G2... • Answered on Jul 26, 2013
0helpful
1answer

Hum in my eons

The hum is because your connecting your speakers to the same power strip or extension cord, try connecting each one from different power source. I had the same problem with mine.
6/17/2013 2:37:48 PM • JBL EON 15-G2... • Answered on Jun 17, 2013
0helpful
2answers

JBL Eon 15 Blown Fuse

These fuses are most likely 3 Amp fuses. Please note that if the replacements blow as well, that there is a problem within the amp section that will require repair.

Dan
5/29/2013 9:33:35 PM • JBL EON 15-G2... • Answered on May 29, 2013
0helpful
3answers

Bloon Fuses!

You don't need schematics to replace the fuses.
Open the speaker unit by unscrewing the back. The fuses are located near the on/off switch assembly. Replace them and screw the the unit back together.
To avoid blown fuses, try lowering the volume.
5/29/2013 9:32:54 PM • JBL EON 15-G2... • Answered on May 29, 2013
0answers
0helpful
1answer

I randomly hear a strange sound coming from my JBL (EON- G2), regardless if it's powered up or not.

is it doing it right now or not or is it your stomach coz you are hungry or not
2/4/2013 4:04:33 PM • JBL EON 15-G2... • Answered on Feb 04, 2013
0helpful
2answers

My JBL eon 15g2 speaker was working fine and then

the braided wires from the speaker connectors to the voice coil could be broken (from repetitive movement) or it could be the voice coil it self that could be cut open from a miss alignment of the cone (ware and tear), delicately push on the cone and feel if it rubs, a simple test is to check the IMPEDANCE of the speaker with a OHMMETER, if you have a reading (4,6,or 8 ohms) than the speaker is fine, check the rest of the wiring, if it reads OPEN than you need a new speaker...
9/4/2012 5:17:47 AM • JBL EON 15-G2... • Answered on Sep 04, 2012
Not finding what you are looking for?
JBL EON 15-G2 Powered DJ Speaker With EQ Speaker Logo

117 questions posted

Ask a Question

Usually answered in minutes!

Top JBL Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5720 Answers

The Knight
The Knight

Level 3 Expert

76823 Answers

Joaquim Martins

Level 3 Expert

1128 Answers

Are you a JBL Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

JBL Audio Players & Recorders

  • JBL Audio Players & Recorders

Most Popular Question

woofer doesnot work horn working but not

  • Audio Players & Recorders
Loading...