...miles ,bearing failure 1800 miles later, no water , mechanic says he never removed pinion nut or crush collar , is this possible!! thanks mike He had to remove the pinion nut and drive flange to ...
I just replaced my rear pinion bearings in my 1995 chevy tahoe and can't get the crush sleeve to crush what do i need to do. i need the manual how to replace the pinion bearing
sino ba crush ko good day, only you may answer who your crush is.... hope this helps, have a nice day
...remember the torque,and when replacing it,torque it back to that spec,the reason being,there is a crush sleeve between the front pion bearing ,and the rear pinion bearing,and it has to be crushed
how to set the crush sleave on a pinion. how to assemble a 1 ton rear end. The crush sleeve is a one time use. You put in a new one, and torque the pinion to spec, and the sleeve crushes during this ...
...you remove the yoke and replace the seal. The issue, however, is that there is a ONE TIME USE crush sleeve that needs to be replaced, between the two pinion bearings. Then the yoke is retorqued ...
...remember the torque,and when replacing it,torque it back to that spec,the reason being,there is a crush sleeve between the front pinion bearing ,and the rear pinion bearing,and it has to be crushed ...
Question about 1989 K1500
...pinion nut torque spec? 170 ft.lbs is the minimum; be aware that this differential uses a crush sleeve to set the backlash and the pinion torque is what crushes the crush sleeve. If you ...
Question about 2005 Colorado
what's the torque on the rear yoke center nut on a 2005 colorado Yoke torque is 400 foot pounds. to crush the crush washer to seat the bearings,,, after the crush washer is seated i believe it 100 ...
Size of rear end crush collar 04 ram 1500 USA? and 4 engines, not old what. (engine power dictates trans and axles used) is this an axle question? not told where eye s or hands touching. so answers ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions