Questions & Answers for: Pontiac Montana crank sensor

...crank sensor malfunction To test this code, have a visual inspection of the location and wirings of the crank sensor. If the engine has a cam sensor, you might mistook it as the crank sensor (it is a ...

Ad

Question about 2005 Montana

1 Answer

trying to change the crange the crank sensor in a 2005 montana the sensor is free and moves in and out is something holding it internaly? No there is nothing holding the sensor from the inside. 

Ad

...crank sensor and timming chain but could it aslo be a vaccum leak What are the actual codes ?Sounds like a problem with the crank and cam sensors.And yes you could have a vac leak but that would not ...

...crank shaft sensor a 2002 Pontiac Montana it cranked up and ram fine. I did this twice each time letting the van rum 3-5 minutes. the 3rd time it would not crank at all so I put a new I replace the ...

Question about 2002 Montana

1 Answer

p1635 where located the crank position sensor 3800 engine it is behind the harmonic balancer (crank pulley) on the right side.3400 engine it is above the oil pan on passenger firewall side of engine.

Question about 2000 Montana

1 Answer

crank sensor or bad ignition module, coil packs can go bad to but not normally all three at the same time.if the coil packs look ok then i would look at what tell it to fire witch is the crank sensor,

...intake, TPS is the throttle body position sensor, the CAM is the cam shaft position sensor (transmission), IGN ignition position sensor and the CRANK sensor is located near the bottom driver side ...

Question about 2003 Montana

1 Answer

...hear fuel pump bit Engine has no spark Have you are dealership check with a scan tool to see if you have a cam sensor, or crank sensor problem. Without these 2 you have no communication with the ...

...fuel pump works. I'm stumped.... Any ideas? Check crank and cam sensor. Check cam and crankshaft sensors. If they fail, the computer won't know when to open the injectors, thus the engine won't

...sit on top of ignition module.You have two crank sensors, if crank sensor issue, check the 7x crank sensor, on back side of engine block, down low, two wire connector, wire colors, yellow and

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...