Questions & Answers for: Dodge Intrepid cooling fan

...off and run fine u may have a cooling fan relay or cooling fan out,,,, the ac may be cutting out because it needs more freon it may not be over heating the low presure swtch is responsible for ...

Ad

...cooling fan out of a intrepid how do i take out a cooling fan out of a 2001 dodge intrepid YOU MUST REMOVE UPPER RAD SUPPORT TO REMOVE COOLING FANS..REMOVE ALL 10MM,13MM HEADED BOLTS..REMOVE 4 ...

Ad

Question about 1993 Intrepid

2 Answers

...check the fan,wire it up direct to the battery,if the wire gets real hot,and ,or the fan does not work,or spins slow,then the cooling fan is bad.If it seems to run fine,replace the cooling fan

...cooling fan is not activating. to check for bad cooling fan turn the car on and turn your ac on. The cooling fans are suppose to turn on, if they dont your cooling fan motor has to be replaced. (easy ...

...cooling fan issues I've got an 98 chrysler intrepid, i put a rad cooling fan from a 95 in there and it doesn't work, is there differences between the 98 and 95 cooling fan models? yes there is a ...

...works One cooling fan will most likely not come on,unless needed,like maybe when the ac is turned on,and the engine is real warm,so get it in that condition,to make sure it is not actualy coming

Question about 2001 Intrepid

1 Answer

...cooling fan electrical connector. Remove cooling fan mounting bolts. Remove radiator cooling fan assembly from vehicle. Fig. Removal and installation of the radiator fan-2.7L Engine shown To install: ...

...cooling fan assembly on a 2004 Dodge Intrepid? Removal & Installation To Remove: Before servicing the vehicle, refer to the precautions in the beginning of this section. Remove or disconnect the ...

cooling fan circuit. It is a generic code applying to all OBD II (on board diagnostics) vehicles. The PCM (powertrain control module) senses the increase in engine temperature through the CTS (coolant

...cooling fan relays or possibly the cooling fans. to check the fans disconnect the plug at the fans and run jumper wires to them both power and ground. if they don`t work then the fans are bad. check ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...