...those bolts solidmounted or do they come out? If you are talking about the ones coming out of the bottoms they are solid mounted. Look for some new
...bottom of the primary case. There is a stud that passes through the primary cover with a 1/2" Nylock nut. The teflon/nylon pad is retained by the steel rocker bracket and lays against the chain. When ...
...sure fairing brackets on bike are not broken 3-be sure riser bolts are not making contact with the bottom of the radio if all of the above are OK, it's either a defective CD drive or bad SDRAM ...
...working and i want to check wiring There is a row of small screws with nuts on them just below the bottom edge of the windshield. Remove these, the windshield support brackets and the light bar and ...
Question about 2001 FLHR - FLHRCI Road king
...installing properly. The bolts that hold the windshield on screw into blind holes. If the bolt is bottoming out before the windshield bracket is tight, you should have some chrome washers of a ...
Question about 2000 FLSTC Heritage Softail Classic
...oil drain plug location for 2000 harley davidson heritage softail The oil tank drain is located on the bottom of the right rear of the frame tube where the tube connects to the cast swingarm
remove exhaust steps in removing the exhaust Hi Anonymoust, start at the bottom rear and work your way forward and up removing fastners that attach the exhaust to brackets and the engine, leaving the ...
...bottom nut to 100-120 in-lbs (11.3-13.6Nm), tighten the transmission exhaust bracket clamp bolt to 60-96 in-lbs (6.8-10.8 Nm), tighten the two bolts with lockwashers, tighten the four TORCA clamps to ...
Question about 2007 FLSTC Heritage Softail Classic
...bottom, push it up to release it as it clips over a locating tab Disconnect the voltage regulator lead from the silver post on the main circuit breaker. Prior to removing the voltage regulator wires, ...
bracket from the bottom of fork stem and bracket. 10. Remove fork stem cap and remove fork stem nut. 11. Lift handlebars from steering head with upper triple clamp attached. Be careful not to pinch or
Usually answered in minutes!
681 Questions
595 Questions
586 Questions
644 Questions
456 Questions