started knockin while driving and i stoped to check oil and water leaks... it was full of oil and water. knocking sound is coming from bottom of the motor or underneath the cab big end or main bearing
...big head screw driver (but car for the trims for it can get damaged) Lever both side vents out, then pull on the trim gently outwards. (long piece from glove box to the end of the radio before the ...
...with 2 big hammers, it should pop right out when hit just right. If you replace just the end, count the number of turns it takes to get it off, and put it back on the same amount. Hope this
Question about 1994 Pickup
...big end torque specs for 2.8 diesel Hilux? 3L engine What are the big end bearing torque specs for 2.8 diesel Toyota Hilux? 3L engine Check in this manual ...
location of starter- need to change and not sure where to start. follow the positive cable from battery (the big one) it ends at the starter
...end will slide off the transmission shaft. You'll lose some tranny oil so have a bucket handy to catch it. You can refill what's lost fter you finish. Now, using your benchvise, press the old u-joint ...
...tools ,if i had seen this question yesterday i could have sent you a complete car for spares ,the big ends had gone and it wasnt worth repairing but the autobox was ok and the rest of the car ...
how do you place thrust washers into a 22r toyota main crank,are they next to the big end bearing? Yes they are
Question about 1990 Pickup
...end, good and tight and not corroded. the regulator is inside your ALT> the ALT has 5 connections 1 is ground. any bad, reg can go nuts. newer cars , go less nuts. they detect more errors and shut ...
I need torque settings for big end bearings toyota 1 tr You've not told engine size.Could be a 22R or a V6.I've no idea.But go to PepBoys and get a Hanes manual for that truck.
Usually answered in minutes!
914 Questions
745 Questions
525 Questions
407 Questions
393 Questions