20 Most Recent 1991 Toyota Pickup Questions & Answers

Using a test lamp, check to see if power is getting to the relay when you turn on the headlight switch. If not, the switch probably needs to be replaced.

1991 Toyota... | Answered on Jul 06, 2019

Sounds like fuel filter.

1991 Toyota... | Answered on Jan 05, 2019

to reset the light you need to remove speedo dash assembly ,on the back of the printed curcuit there is a small screw and a hole next to it remove screw and fit to empty hole . refit assembly

1991 Toyota... | Answered on Dec 19, 2018

1990 22re same problem surge when pedal was depressed thought it was booster or check valve still didnt fix it i even put a brand new booster on it just to make sure still no fix it finnally went away on its own for about a month now it does it just sitting at an idle with out the brake pedal depressed traced all vaccum lines no problem there and still have no clue

1991 Toyota... | Answered on Dec 04, 2018

efi main relay,circuit opening relay,airflow meter door stuck..need more info and i can tell you how to fix or at least where to look.

1991 Toyota... | Answered on Feb 05, 2018

First off...do not follow some of the posters on youtube telling you to grab a moving fan blade with your fingers. Good way to lose fingers doing that.
I am going to post a link for a youtube video that will give you a bit of direction on how to safely determine if you fan clutch is bad or almost bad.

Mercedes How To Safely Check Cooling Fan Clutch

Semper Fi,

1991 Toyota... | Answered on Jan 29, 2018

Check the bolt that holds the back of the transmission to the cross member. It may have fallen out, allowing the transmission to shift right. If that is ok, remove the stick shift boot to see if the stick it hitting the edge of the floor board opening.

1991 Toyota... | Answered on Jan 10, 2018

does it have ac if so watch your ac compresor if it engages and your rpm drops at the same time thats the issue

1991 Toyota... | Answered on Nov 10, 2017

indicates you have installed the clutch plate incorrectly
the raised hub section is hitting on the flywheel bolts instead of facing back into the pressure plate
only fix is box back out and turn the plate around

1991 Toyota... | Answered on Sep 22, 2017

Is it auto or manual. Does it seem to be using all the fluid from the plastic overflow/filler bottle after each start. If its a electric fan, does it work??

1991 Toyota... | Answered on Sep 03, 2017

hello, it takes about 5 hours actual time for a mechanic using air powered tools and has all the equipment needed such as a transmission jack, a lift and the tools needed.
\Keep in mind that this time varies depending on the skill and experience of the mechanic, the shop can charge you whatever they feel is fair and still make a profit, most shops charge a 'flat rate' this means they have a set price for each repair procedure, this also varies with location. a shop on the east or west coast will tend to be more expensive than in the Midwest.

1991 Toyota... | Answered on Aug 26, 2017

It's in the junction box, left kick panel

1991 Toyota... | Answered on Jun 27, 2017

Sounds like you have no Torque converter lock up function. The wiring connector for T/C lockup solenoid must have been disturbed or the solenoid is bad. No lock up will make a 200 RPM difference in high gear

1991 Toyota... | Answered on May 24, 2017

You MIGHT have a vacuum leak which is affecting the timing.

1991 Toyota... | Answered on Apr 09, 2017

I don't know if there are any rebuild kits, I haven't heard of any, but your local parts store like an O'Reilly's should carry a universal portioning valve for around $80.00 or you can try Toyota for a new one $$$ or try Ebay, they vary in price from about $60.00 - $400.00. http://www.ebay.com/sch/i.html?_nkw=toyota+brake+valve

You could also try taking it apart and cleaning it, if the brake system was never flushed on a regular basis, then more than likely it's not a defective valve, it's just clogged up with sludge.

1991 Toyota... | Answered on Sep 19, 2016

you definatley have a crack in cylinder head or block,,may be a head gasket too,,,you need to take it a part to see the problem,,no easy fix..not what ya want to here sorry..

1991 Toyota... | Answered on Jul 21, 2016

Not finding what you are looking for?

1,085 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Toyota Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Pickup Toyota

  • Pickup Toyota

Most Popular Question

far replaced alternator battery relay

  • Cars & Trucks