Questions & Answers for: Ford F-150 belt sensor

...belt is okay, whats the chances of a cylinder head temp. sensor going bad, and where is said sensor located, and can it be replaced without going thru dealer service might need to be burped (serious) ...

...SENSOR OR SENSORS. If you got the repair done correctly, and this is a power train code ( a Pxxxx ), 2 drive cycles should clear it. If it is a Pxxx code that is for the SRS, this is not the case. If ...

...and passanger airbag and hooked up. I was told i now need new sensors which are located in the seat belts. Is this correct? this may sound crazy but this is what they say (manufactor) when ever ...

...belt, got underneath and wires came out of plug that goes in the crank sensor, put back wires in the clip and connected back on the sensor female plug, truck turns but doesnt start, got 10 gallons of ...

I have a 2001 F150 SLT it starts with out serp belt on. Put new Alternator and belt cranks wont start gages going crazy. Take off Belt it starts. are you sure you have the belt routed correctly. this ...

...belt onto the air compressor's pulley. Read more: How to Replace the Crankshaft Sensor in a Ford F-150 ' eHow.com ...

...sensor cause this? If not, What else could it be? 216k miles. I don't think its the CPS, but I do know that WD40 will make a squealing belt even worse. If you havnt replaced the belt yet, I would do ...

...Sensor, the VSV Valve (Oil Control Valve), the timing belt and water pump, and have cleaned the VTV Actuator and replaced and sealed the O Rings and we still get the code. Anyone??? Maybe the cam ...

...run fault codes to determine the sensor that is faulty. Check for cam/crank position sensor. Check that the cam shaft is turning(broken timing belt/chain). Check that the immobiliser is

. The F-150's airbag sensors are located under the driver and passenger seats and inside the safety belts. The location helps the airbag unit determine when ..