...and not 100 MBPS (green light), so check your network cards speed. this is likely an ethernet auto-negotiation problem between the switchport and the connected device. If you want this to stop, ...
can't get internet connection I have a cisco 24 port switch which is conncted to a cable modem. I also have a aple Airport connected to one of the terminals. When i wire my PC to the airport i get ...
...there is not a faulty cable. 6. Verify that each device supports 802.3z specification for Gigabit auto-negotiation. Gigabit Ethernet has an auto-negotiation procedure that is more extensive than
...information as well. router>en router#conf t router(config)#router eigrp 69 ***69 is the AS (Autonomous System) number*** router(config-router)#net x.x.x.x y.y.y.y ***x.x.x.x=subnet, y.y.y.y ...
...interface Ethernet0/0 ASA5505(config-if)# switchport access vlan 2 ASA5505(config-if)# speed auto ASA5505(config-if)# duplex auto ASA5505(config-if)# no shut ASA5505(config)# interface ...
I have connected two Cisco 2851 router at both the ends via HWIC-2T card on it. I configured ip address on both ends and set Encapsulation as ppp But my link is not getting up. It is saying Serial is ...
Question about Linksys E1000 WirelessN Broadband Router Network Routers
...no complete setup. Is there anything I can do? if you're running windows 7 sometimes it tries to auto detect the type of network but doesn't ask for a password, when it starts to try to auto
Question about WAP200 802.11b/g Wireless Access Point
...auto-crossover capability, using a crossover or regular network cable would be irrelevant. What kind of switch are you plugging it into? Cisco switches, for example, can have MAC restrictions or othe ...
...Connected to LAN *** ip address 192.168.1.1 255.255.255.0 ip nat inside ip virtual-reassembly speed auto full-duplex ! interface FastEthernet0/1 description *** Connected to F@H *** ip address ...
What is a crossover cable That's an 8-conductor unshielded twisted pair cable whose plugs are wired EIA/TIA 568A on one end and EIA/TIA 568B on the other end.
Usually answered in minutes!
57 Questions
67 Questions