Right memory for Dell Inspiron 1300 ME051 Intel Celeron 1.60 GHz, 533 Mhz

Yes as long as it is the same case stile and 400 mhz.
Base processor Intel Celeron 2.7 GHz

• 400 MHz Front side bus
• Socket mPGA478
  Note.... Make sure you use PC2700 memory PC2100 will give you error messages
  

Mother board d102ggc2
• Support for DDR2 533 MHz and DDR2 400 MHz DIMMs
• Support for up to 2 GB of system memory

Gigabyte GA-945GZM-S2 - motherboard - micro ATX - LGA775 Socket - i945GZ specifications

• it looke like the supported RAM
• Supported RAM Technology DDR2 SDRAM
• Supported RAM Speed 533 MHz , 400 MHz
• hope this helps
• General
• Product Type Motherboard - Micro ATX
• Cache Memory None
• Chipset Type Intel 945GZ Express / Intel ICH7
• Max Bus Speed 800.0 MHz
• Processor Socket LGA775 Socket
• Max Processors Qty 1.0
• Compatible Processors Core 2 Extreme , Celeron D , Core 2 Duo , Pentium D , Pentium 4
• Memory
• Max Supported Memory 2.0 GB
• Supported RAM Technology DDR2 SDRAM
• Supported RAM Speed 533 MHz , 400 MHz
• RAM Features Dual channel memory architecture
• Graphics
• Graphics Controller Intel GMA 950
• Memory Allocation Technology Dynamic Video Memory Technology 3.0
• Audio
• Type High Definition Audio (8-channel)
• Audio Codec Realtek ALC888
• Compliant Standards High Definition Audio
• LAN
• Network Controller Marvell Yukon 88E8001
• Network Interfaces Gigabit Ethernet
• Modem None
• Expansion / Connectivity
• Expansion Slot(s) 1.0 x Processor ( 1.8 V ) - LGA775 Socket ( x4 mode ) , 4.0 x PCI Express x16 - DIMM 240-pin , 3.0 x Memory , 1.0 x PCI
• Storage Interfaces Intel ICH7 : ATA-100 - connector(s): 4 x 7pin Serial ATA - 4.0 device(s) , Intel ICH7 : Serial ATA-300 - connector(s): 1 x 40pin IDC - 2.0 device(s)
• Interfaces 1.0 x Audio - Floppy interface - Mini-phone stereo 3.5 mm , 1.0 x Storage - Line-out - 6 pin mini-DIN (PS/2 style) , 1.0 x Audio - RS-232 - 25 pin D-Sub (DB-25) , 4.0 x Serial - VGA - Mini-phone 3.5 mm , 1.0 x Microphone - Line-in - 15 pin HD D-Sub (HD-15) , 1.0 x Keyboard - Generic - 6 pin mini-DIN (PS/2 style) , 1.0 x Display / video - IEEE 1284 (EPP/ECP) - 4 pin USB Type A , 1.0 x Audio - Line-out (center/subwoofer) - Mini-phone 3.5 mm , 1.0 x Network - Generic - 34 pin IDC , 1.0 x Parallel - Line-out (side surround) - RJ-45 , 1.0 x Audio - Line-in - Mini-phone stereo 3.5 mm , 1.0 x Hi-Speed USB - Line-out (rear) - 9 pin D-Sub (DB-9) , 1.0 x Audio - Input - Mini-phone stereo 3.5 mm , 1.0 x Mouse - Ethernet 10Base-T/100Base-TX/1000Base-T - Mini-phone stereo 3.5 mm , 1.0 x Audio - 4 pin MPC

Hello,
The Intel® Desktop Board D845GVAD2 supports a single Pentium® 4 processor with a system bus frequency of 400 MHz or 533 MHz, or a single Celeron® processor with a system bus frequency of 400 MHz.

So you can install upto 3.06 GHz 533 MHz(cache memory) processor and also update the ram 2 GB 400 mhz.
Dont install Prescott processor.
Hope it will help you.

512 MB of DDR2 533 MHz system memory, upgradeable to 2 GB using two soDIMM modules (dual-channel support)

Yes its possible
Yes but the memory its going to run at slow speed 533Mhz

check the laptop specifiction from the Acer website....

Hi again!

Yepp, you can upgrade it to 1GB memory
This is the spec of the memory on your 2055:
Memory RAM Technology DDR2 SDRAM Max Supported RAM 1 GB RAM Speed 533 MHz Installed Cache Memory 1024 KB

Good luck
Nic
DONT forget tp RATE me

here are the specifications of *********** board go through it...
Processor Support Intel® Pentium® 4 processor, Intel® Celeron® D processor and Intel® Celeron® processor in the 478-pin package
Note: It is important to verify supported processors before using this Intel® desktop board. Supported front side bus speed 800, 533, and 400 MHz Integrated Graphics Intel® 865G Chipset with Intel® Extreme Graphics 2 Chipset Intel® 865G Chipset AGP Connector AGP 3.0 (4X & 8X Speed 1.5 and 0.8 Volt Only) Memory Type Dual Channel DDR 400 MHz (PC3200), 333 MHz (PC2700), and 266 MHz (PC2100).
Note: Be sure to review important memory and system bus speed considerations before using this Intel® Desktop Board Max Memory Capacity of up to 4 GB Memory Slots 4 DDR DIMM Sockets Slots 6 PCI
So it will support DDR2 and you can upgrade upto 4GB...

This chip will not work in your machine. You machine takes the PC4200 or 533mhz memory, the kingston chip you listed is 667mhz or PC5300. A very useful site for memory configuration is patriotmem.com

No. DDR replaced the SD in RAM so SDRAM and DDR RAM are two completely different things but each ram type has its own frequency hence you get SDRAM 100(mhz) and SDRAM 133(Mhz) just like you get DDR 1 RAM at 266(mhz) and 400(mhz) and DDR 2 RAM at 533(mhz) and 800(mhz). Therefore as you can see how these things differ, but if your mboard takes SDRAM that it can take and frequency of SDRAM but you must ensure that all the frequencies of all your RAM modules in all your slots correspond otherwise you will have problems, meaning that if you decide to use 133mhz RAM then all your RAM modules that you use must be the same. Let me know how you go. thanks

regards