Sony KV32s22

sounds like a thermostant its that or overheating could be a water pump impeller

is the power light or lamp light blinks? if its the lamp then replace it. your tv lamp model # XL-2400. check this link https://servicesales.sel.sony.com/ecom/accessories/web/viewItemDetail.do?operation=getItemDetail&itemID=600259&searchOperation=modelSearch&searchText=KDFE42A10


or if its the power light that blinks then turn off tv for 5 mins. unplug power cord for 1 min. try plugging the power cord directly into working wall outlet. if same, tv needs service. visit eservice.sony.com website to check service option

is the lamp light flashing? if yes, lamp needs replacement. you can buy lamp from www.sony.com/dapc

if lamp light if not flashing, turn off tv for 5 mins. then unplug for 1 min. if the same. tv needs service. check www.eservice.sony.com

unplug the tv, wait 5 mins plug it back in, and without using the remote, press the tv on button. see if its ok.

Look at this link on the bottom to see what the blinks tell you.

http://www.agoraquest.com/viewtopic.php?forum=70&topic=31721

Mike

Symptom shows lamp is weak and requires replacement.
Please buy Sony original lamp for TV safety and good picture result.

If your set was manufactured around July 2005, you may need a firmware upgrade to solve this issue. On the Sony website you can enter your model # and serial # to see if you TV is affected. If so, it is easy to have done and may be free from Sony. It sounds like the issue they described in the writeup on the required formware update. I had mine done within few months of when i bought it (purchased in Dec 2005) and it has been working flawlessly since.

Good luck!

Donnieboy999

Yup, it seems a lamp problem can give a blinking green light over the 10 times (1 - 10 times for diagnostic codes), but in my case rather than replace the bulb if it works for a minute then resets with the green light blinking, do what I did.
Take the lamp out and inspect it, it has breather screens top and bottom, if it cant breath because there clogged with dust, clean them, and you can remove the screens, use q-tips and clean the inside. I saved the cost of a lamp and it's working fine!

the tv will try to reboot a few times. just let i try and eventually it will start blinking red. if you could count the red blinks then i can further assist you.

Sounds like a bad SSB(small signal board) module. Better take it to a RCA AUTHORIZED service center.