In life fitness next generation operation elevation is not working.!What is the problem?

Life Fitness 95Xi Crosstrainer Console Support cover Replacement
However open for some loose wire, or if there are using Batteries, or usint Generator see the power supply is o.k
Blessing.
[email protected]
cell+whatsAPP:+50588611441

http://www.profitnessmd.com/Manuals/CTG%20Operations%20Manual.pdf

just bought a amazing model after reding review on this site thanks amazon rock http://www.pianoforall-review.com/life-fitness-treadmill-reviews-does-it-works/

Dear Sir:
Please RUN the software calibration for diagnose, troubleshooting, and fix.

2) LUBE the deck belt, the proble is shut down because enough friction produce from worn deck. In order to protect the electronic system, the machine shut down.Proceed in accordint with the instruction manual.

3) The software c, will guide you what is wrong with the elevation motor.a)try to lube the motor gear b) adjust the potentiomente,c) tigh the connector wires from elevation motor.d) some machine has relais for up and down, clean the contacts.

See my personal TIPS for HELP.

sincerely. God bless you.

hi
check the home switch
it is indicator of elevation
when you look under the tredmill where elevation motor you will see white plastick pin coming down through the hole just check it if still there and pressed it is usually 95 % of elevation problems

if it is not then open the hood and check elevation connections


let me know if it is not these problems post it i will give you system check code
thank you and good luck

hit the stop button and hold down pouse key until the counsel repowers up and tougle throug to mantinace enter then tagel throug to waxer refill and hit enter

Every time I have gotten this message, I have had to replace the motor controller.

Send an e-mail to [email protected] to request the Life Fitness 9000 manual for free.

Usually its the display panel not sending the proper signal - look under the display panel on the left side if standing on the belt, there is an access opening and there will be 3 plugs or connectors, it is the smaller 2 prong connector, just unplug and replug to clear the connection, that usually fixes mine, while in there unplug and replug all 3 plugs just to be safe.