Intermec CK30 Error Opening Wedge Problem

hi
o obtain the MAC address on a CK3X, CK3R,and 70 Series Handheld computer, follow the steps below:

1. Tap the 'Windows' button on the lower left hand corner.
2. Scroll towards the bottom of the Windows screen to the "ISpyWiFi" application and tap to launch it.
3. ISpyWiFi will open up in the ISpy tab.
4. At the top of the screen, look for the 'WiFI NIC' quadrant which displays the MAC address.

you must have a network issue or the CK30 experienced a power surge, if you have others that work, then that unit could be defective and needs service.

hi

call Motion Technology Solutions Inc., ask for xt 29, they have 23 units in stock
905 266 9884

http://www.intermec.com/support/downloads/index.aspx

here is the download site we use for intermec downloads its safe fast and free good luck

please remember to rank this advice

sonic boom electronics

Hello jcapsto. It could be that the backup or 'flash' battery isn't totally charged for one reason or another. This little internal battery keeps a minute current going to the units' flash memory that holds settings and other data and allows warm boots. I would recommend putting your CK30 in it's cradle with the main battery in overnight. Then trying removing the battery and it should spring right back to life. If not, then I would pin the issue on your backup battery and would implore you to contact Intermec or the vendor you purchased it from about replacement/repair. I hope this helps to at least isolate the problem. Good luck!

Return it to the manufacturer for a refund, or a replacement.

The ck30 does not have a desktop. Press the green then orange key to access the system menu. Alt then escape will bring up the task manager.

Left the ck30 powered off and removed the battery. Replaced the battery with a fully charged one. After a couple hours rebooted the ck30 and it booted normally. My ck30 was tied to the AS400 system. I think this may have been a factor with this issue.

upgrade your memory