Projection light i have replaced the the projetion light. now the error message wont go away. how do you make it go away? here is the tv model Sony KDF 46E2000

for a possible answer please provide the Model number as there are several hundred Sony projection models that are different.

The tv LED light "LAMP" indication it is flashing too or lite up?The tv projection lamp has it been in the tv like 1 1/2 or 2 years already and tv in uses it like 4 or 5 hrs everydays?Yes?The tv projection lamp life has ended.Tv require a new projetion lamp.Dose this whole blinking lights 34 times cycles have like clicking noises to it too.Yes,than the board that call the Ballast board it is also dead.Tv must it Ballast board replace too.This Ballast board only job are to ignite the tv projecion lamp only.

you eed replace the convergence kit, (2) stk-392-560 ,and the picofuse 5 amp in your pwr.s.

has squiggly line on top

This is an all-to-common power supply failure due to bad capacitors in power supply. Very common in new tv's.

you need to replace the lamp.

http://www.somelifeblog.com/2007/06/sony-projection-tv-red-line-repair.html



Go to this Blog. It "should " solve the problem.
Really, Really simple, do it your self solution !!
Instructions and pictures included :D

Ken , the poster of that Blog writes........

"The problem is with the convergence via the voltage on the
color ray gun tubes that get out of adjustment.
They are also known as retrace lines."............


This blog covers many makes and models with many
issues solved, just with that one solution

Give it a try, it's FREE and SIMPLE :D


Hope the blog helps you also :)

Jean

Vertical deflection has stopped change IC 8003 on the A board

I Have A
Samsung rear Projetion Tv Model No. PCJ522R i was cleaninthe inside when i spilled oil on half of the board power supply,when the tv is connected power button is light up but wont turn on,what can i do?

This sounds like the solder joints on one of the convergence output IC's have cracked loose or the IC itself is defective and quitting when it warms up. The IC needs to be either resoldered or replaced.