I have an Optimum 60100. It powers up normally – display etc works. When I press “start” – NOTHING happens (motor does not move or make any sound. After a while the E1 message appears. If I manually move the belt of the treadmill after I have pressed the “start” it keep on displaying on the screen; until I stop moving the belt. Just after I have stopped moving the belt manually, the E1 message appears. Could you please suggest what could be possible reasons for this? Also, I live in Hamilton New Zealand. Is there someone in this area that can work on the York?
Dear Sir:
This is probably a 1) faulty speed sensor or 2)the speed sensor is not
plugged in properly. Its also possibly a 3) faulty motor control board or
lower board 4) Main motor faulty. . The error codes will differ between makes and models but
could be e1.You must test
see my personal TIPS for diagnose and troubleshooting.
See if you can run the software calibration for diagnose and trouble.
sincerely. God bless you.
ernesto cuadra
managua, nicaragua. c.a.
SOURCE: york tv evolution treadmill e1 problem
INDICATE ABRUPT SHUTDOWN of the belt as the motor control detect a sharp increase drive current,and inmediately stop driving the belt. Watch this videos tips:
http://www.youtube.com/watch?v=qgb2TY3WCkg&feature=related
http://www.youtube.com/watch?v=-oeXTKqWECw&feature=related
http://www.youtube.com/watch?v=GPI6dFJCUA4
http://www.youtube.com/watch?v=bF3OyQ3HwfU&feature=related
http://www.fixya.com/support/r10724803-measure_voltage_in_transforme_fitness
http://www.fixya.com/support/r10786838-test_procedure_dc_motor
1,352 views
Usually answered in minutes!
×