I Need de last firmware version for 3Com Superstack II 3300xm Switch

take it to the 4s garage, if you want to find out the problem by yourself,you first have some professional tool , there are some diagnostic that always can figure out the problem i can show you: www.xcardiag.com/

There a great article at General Router Setup.
If you need more help post back!
Thumbs and testimonial are welcome!


There is a great article at Working with Windows Wireless Networks
If you need more help post back! Thumbs and testimonial are welcome!

If you donot have the default IP of the router, try setting an IP as 192.168.1.2 on your machine & access 192.168.1.1 (which is supposed to be the default IP of the router)

The last part of the IP address has to be more than 10 apart. That is to say: if your first address is 193.156.36.90 then your second should be 193.156.36.100 or higher or 193.156.36.80 or lower. I like to go for 50 higher or lower then you are well out of the range of your main router.

I've got a Superstack II 3300 24port switch, all leds are on, and led 8 blinks.
I'll let you know if I find a solution.

switch dont restart by themselves without command, first remove the switch from the network, disconnect from internet, make sure you hadn't fired anybody recently it sounds like a hack. reduce network traffic to local area only and priortise important internet traffic. now got back to the switch and troubleshoot make to check the reboot command on error or when error is found, if the problem stops when the switch is remove somebody is messing with the network.or the darn switch is faulty install a new one.

All yo need to know is the physical size, the voltage and current.
They are usually on the little round label. Voltage is probably DC 12v, and the current should be something like 0.5 amp or 500mA, or 215mA or something similar.
Then just you will know which one you need.

Hi,

This is the problem with power adopter. Please replace you adopter and let me know...

Rajeev

A blinking power LED means that the switch is either downloading software, or is initializing which also includes running the Power On Self Test. You may have firmware issues with the switch and/or the switch is stuck in initialization mode. You may have to contact 3com regarding a warranty issue. Hope this helps. Good luck.