20 Most Recent
Speed Queen AWS44NW Top Load Washer Questions & Answers
When the spin cycle begins the washer vibirates
The machine is probably not leveled properly. To level the machine, partly fill it with water. Make sure that the drum is standing in the middle of the machine and then adjust the machine until the water is at the same level all around at the nearest set of holes to the water. Check that the drum is still in the center of the outer drum. Make sure that the adjusting feet are all firmly on the floor and that you cannot rock the machine at all by hand. A top loader must be 100% level or it will shake.
The drum vibrates when the machine is on spin. I
Hi from retired Englishman in SW France,
It is necessary to ensure absolutely that the machine has all 4 feet very firmly on the floor, and I mean firmly ;-0)
Doesn't matter whether it is empty or not but switch it off then-
very firmly push one front corner diagonally into the centre of the machine and see if the machine moves or rocks AT ALL, even the slightest. If it does you will need the open-ended spanner which came with the (new) machine........which of course went missing a long time ago?!! An adjustable spanner will suffice.
Adjust the foot under that corner downwards until it is very firmly- almost pushing- against the floor but not so far that the corner lifts up!
If this corner did not rock do the same to the other.
Once you cannot rock the machine the slightest little bit, screw the locking nuts up tight to the underside of the machine so that they will not move. Ideally the rear feet should also be locked.
(If this has not cured the problem it is possible that the internal suspension is malfunctioning- but you can see the springs. Shockers?)
If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck!
John C
Hi my clothes are coming
have you yryed wiping the inside of the drum down with a rag and running it threw a empty cycle with bleach...
Machine is leaking. It is probably 15 yrs+ old.
Hi from retired Englishman in SW France,
I'm sorry but it would be impossible for someone here to diagnose remotely how the leak could be caused. All that can be suggested is that you call for a service engineer ;-0(
Sorry again we cannot help.
John C
Not finding what you are looking for?