JVC KW-AVX800 CD Player - Answered Questions & Fixed issues

resolved already?

Reset code 08 is usually relates to data connection between head unit and the tuner. If there is any other peripheral units between the main unit and the Satellite tuner, check those also. Remove, clean with contact cleaner and reinstall should take care of majority of issues.

is there a diagnostic setting for touchscreen calibration. Could have gone bad. you are probably still in warranty, take that bad boy back

send a picture to [email protected]

You'll find the wiring diagrams in the installation manual.

if the screen gets wet it will corrode at the data wire and not pick up a signal

htere is a newer attachment that u have to buy for all the newer ipods like the touch and up

Computers are the only devices that are capablel of capturing media from another device to purform manipulations. Computers by nature are designed to allow for several device to device connections data manipulations all as designers or prorgammers development initiated.

http://books.jvc.com/booklist.asp?Model=KW-AVX800

you may be able to get a replacement screen at pacparts.com.

try pacparts.com.

somtimes you have to disconnect power to the unit. pull the unit out and unplug it or disconnect the battery. if it doesnt work you may need a hammer.

buenas amigo , esa unidad posee un eprom 24c01 dentro del tuner hay que desmontarla y leerla luego postear el dump en digitalkaos.com ahi entre todos te ayudaremos

hi , those units have the touchscreen conector in the lower side of the screen , it happends lose one or 2 conductive tracks from the flex to the screen it can be fixed with a conductive pen , can check visualy where is the open loop n'd aplly just few conductive ink to restore the circuit ,

Hi,

You can download and print the instruction manual in PDF format by clicking this link.

To download Installation manual, click here

Please note: Adobe PDF Reader is required to view this manual. Click here to download the latest version of Adobe Reader.

Hope this solves your problem. Thanks for using FixYa.

JVC KW-AVX800 The black wire is your ground The yellow is your positive 12v constant so connect this to the wire that has 12v when the car is off. The red connect this to the key switch wire meaning the wire will have a 12v signal only when the key is tured to the on position. The blue is for a power antenna the blue/white stripe is if you have external amps this wire goes to the amps remote on The orange/white stripe connect this wire to your cars dimmer switch Happy Wiring

You cannot run a External Hard Disks (...that's what the User Manual say) It only reads Flash Drives, I have tried 8GB.

its usally blue or yellow, its a thin wire not a thick 1

Hi
Make sure you are using clean/non scratched discs, Also your lasor needs cleaned, If you are any good with your hands take the top off your system, locate the lasor "eye" and rub it gently with a cotton bud dipped in methylated spirits then rub it gently with a dry cotton bud making sure not to leave any fibers from the bud on the "eye" put the top back on, This should do the trick, Hope this helps.

The remote wire on the jvc unit is blue/white stripe if that isn't there it's the blue wire