20 Most Recent Miele S7210 Bagged Upright Vacuum Questions & Answers

Is there a belt? Check the tension, it may be slipping.

Hello, Do you still have this vacuum cleaner?

you will need small star screw driver to do thsi once it i open be careful there are 2 little springs on the sides under the brush rller

It is possible that you may have pulled the machine too far and possibly broken a wire most likely near the plug end or within the machine itself.

You will need to remove the screws where the cable enters the rear of the vacuum . You will notice the cable is retained with a small plastic clip , remove this clip, unscrew the cable cut out the damaged section and reconnect. Ensure retaining clip is replaced. Now put the screws back into the machine body,

Hey, this is Tristan with Crucial Vacuum, In order to remove the hose to start unblocking it, do the following: 1. Put the vacuum in the upright position 2. Press the release button of the telescopic wand and remove the handle from the hose 3. Push the hose elbow downward into the catch hooks. 4. Undo the suction hose by twisting it at the elbow. If the blockage isn't in this location you can do the following to search further for blockages: 5. Open the service flap on the back of the vacuum. 6. Unscrew the screws and pull the cover free. Below I have attached a link to the users manual for the Miele S7210. You should refer to page 30 to view the diagrams pertaining to my suggestions. http://www.sylvane.com/media/documents/products/miele-s7210-twist-upright-vacuum-users-manual.pdf --- You can purchase replacement parts for Miele direct from Crucial Vacuum with free shipping and an exclusive 10% coupon for Fixya.com readers, use code: FIXYA10 http://www.crucialvacuum.com/miele.html I hope this was helpful! If you would like further assistance, please feel free to give us a call at 877.750.9239. We have helpful and friendly customer care representatives on the line ready to assist you. Tristan Clausell Crucial Vacuum Customer Care http://www.crucialvacuum.com

Best to have the power cord replaced. Take it to an appliance repair service and have the work done. Most cords have strain reliefs that you cannot replace, and when missing you problems will just reoccur faster.

If your miele is laying all the way down like mine is and will not stand upright..look for a dark gray corrugated plastic part where the handle bends at the base. This is above the silver holed plastic filter holder. This may be stuck. I just pulled mine out and then I was able to stand it upright again. I wasn't able to put it back in but I think it is there just to cover up the inside workings of the vacuum. So I left it out.

they go in the corners underneath the brush bar