20 Most Recent
Sharp AQUOS LC-32D44U 32 in. LCD TV - Page 3 Questions & Answers
Sharp tv troubleshooting
Check its speaker first. If it is found OK, connect the set to any external amplifier If no sound is produced by external amplifier too, the main digital board has the fault. If there is sound by external amp, and not with TVs internal speaker, the fault is with its audio output stage circuit. If you wish to get more details, surf the
following link. There are over two
thousand and four hundred posts. All
are related to television and other domestic electronic equipment service help. You can get a solution there. More than Nine Lakh viewers cannot be wrong.
http://electronicshelponline.blogspot.com/
The firmware do not finish.. just turn off and
Unplug the ac power cord from the wall for 30 seconds then hold down the power button on the tv, not the remote, and while holding down the power button plug the ac powercord back in and continue holding the power button untill the tv turns on. This is a hard reset back to factory defaults.
I am not getting picture on my TV it stic on only
That blue K means you are in the service mode. Unplug your set and wait 30 seconds. Then at the same time you plug it back in, you need to be holding the volume down button and the input button.
The TV should turn back and the blue K should turn pink. Once this happens, press the volume and channel down button at the same time. A menu should come on the screen. With your remote, press the up arrow to reach the nest page. The first option should say INIT. Arrow to the right and hit enter. In a few seconds your screen should turn green and say success. Unplug the TV and wait 30 seconds. Plug the set back in and turn on your TV. You can then set your set back the way you want.
Not finding what you are looking for?