2006 Yamaha Ybr 125 Diversion "switch" Questions

how to remove ignition switch from Yamaha YBR125 The ignition switch has been attached by headless bolts/rivets They will to be drilled need out. Please rate this solution

Removal of the individual switches from the switch housing To remove the switches in the fork housing, remove the ignition switch (place key in switch, turn it to acc then press the tab to the lower ...

...in the bulb, one for the brake light and one for the tail light. If the bulb is good, there are two switches that turn the brake light on. One is on the front brake lever and the other is a pressure ...

replace ignition switch key turns 360 degrees, can't turn it off.. There is a groove in the ignition switch housing, the groove runs 90 degrees to the threads on the switch. You need to align the ...

replace ignition switch you tell me! 1. Remove seat. Always disconnect the negative cable first. If the positive cable should contact ground with the negative cable installed, the resulting sparks may

...won't work The headlights and the starter won't work. I read another post which said it was the switch. Does the switch mean where you put the key in. If so, do i need to buy a whole new switch? ...

...the sensor. I don't know what sensor you're talking about unless you're talking about the pressure switch underneath the bike. Loosen the bolts that hold your front master cylinder on to the ...

When the on/off switch on the handle is put to "on" the main fuse melts within 1 second. There is a hot wire going into the switch. Somewhere at the switch or after the switch the power is ...

will not shut off with key or kill switch it shuts off by lowering the kick stand and putting it in gear. you have a disconnected wire in the switch housing on your on off switch. either broke wire or

My 87 k100rt bmw left hand indicator switch doesnt work reliably My 87 k100rt bmw left hand indicator switch doesnt always activate the indiactor, right hand and hazard works fine. I have test ...