Question about Yamaha YZ 426 F Motorcycles
...remove rear timing chain tensioner guide on '98 tE410 Do I need to remove the chain first.Do I need to remove the head? i took the chin off a suzuki quad (4 stroke) and only had to remove the vavle ...
...timing chain back on. remove the right hand inspection hole from the engine cover turn the engine over with bolt in the hole and set the mark to no 1 tdc on remove the cam chain tensioner set the ...
...remove the front r/hand engine cover this is the crankshaft pulsar cover, you will need a new gasket here, then you will observe the timing marks on the crankshaft t/= top dead centre, and the ...
Question about Yamaha YZ 426 F Motorcycles
...chain where it enters the bottom of the clutch drum. Remove the engine sprocket nut and slide the compensator/sprocket assembly from the engine sprocket shaft. Slide the reluctor bowl off the engine ...
remove the chain you must remove both the front sproket and the rear clutch basket, etc. But before you can do this you must lock the chain from moving, Harley makes a tool for this or if you are very
...chain tool, you remove the small grub screw and use the small bolt with the pin to push out one of the chain's pins. No grunting or swearing required. Then comes sprocket replacement. Six nuts on the ...
...timing on it, to this you remove the tensioner and then unbolt the cam sprocket and make the chain jump a few links until you think the 2 dots are aligned with the arrows, hook the sprocket back onto ...
...chain tool, you remove the small grub screw and use the small bolt with the pin to push out one of the chain's pins. No grunting or swearing required. Then comes sprocket replacement. Six nuts on the ...
...Remove the clamp and slide the rubber boot off the clutch in-line cable adjuster. 3. Loosen the adjuster locknut and turn the adjuster to provide maximum cable slack. 4. Make sure the clutch cable ...
Question about Yamaha YZ 426 F Motorcycles
timing chain tensioner malfuncion (try to check with another chain from other xj from a friend or dealer..) or missadjustment, this could be check easyly by removeing it and fitting it again properly.
139 questions posted
Usually answered in minutes!
652 Questions
453 Questions
469 Questions
316 Questions
292 Questions