Question about Chevrolet Silverado 2500
dropped since bowl was not full enough to keep float needle in place. This could be from improper adjustment during carburetor overhaul. When floats are set, some have adjustments for both
Question about Chevrolet Silverado 2500
rod. I am also told that the cost to install a used engineis about 4 or 5 K. I repeat this is a 1996. I'd like to drop the oil pan, identify the sloppy rod, replace the bearing, and pray that it's not
...the rod cap, and then push the piston and rod out the top. If the car was not so new, you would also have to **** the ridge off at the top of the cylinder. But probably unnecessary after only 4
...dropped but to do the job correctly requires engine removal, crank re-grinding or replacement and oiling system cleanout (expensive). Wristpin (piston/rod assembly) can be serviced without engine ...
Question about Cars & Trucks
...dropped to 15 psi and the buzzer came on , now if I drive it 4 miles, pressure low and buzzer comes on. I can only tell you that in my Cat engine, as the crank and rod bearings wore further and ...
...4, there it got tight harder to turn and push rod seemed a little shiner. Went underneath to drop the pan but it won't drop unless I lift the motor A knocking sound in an engine can be an indication ...
...THREE DAYS CANNOT GET THIS IN TIME. IT HAS ONE OF THOSE FLAT DISTRIBUTORS WHERE YOU DROP IN AT 4 O'CLOCK AND IT MOVES TO 2 O'CLOCK AND YOU LOCK IT DOWN, PLEASE HELP What kind of car and engine is
...dropped the back 4 in and the front 2 in. Now I cant manually pull the shifter into low gear. I have been told this problem could be from the geometry changin after it was lowered. I dont have to ...
...4 times you stab a dist in place The 289 has the small hex rod to the oil pump, So I'm sure it's a matter of twisting the rotor a little back and forth while you stab it. It's a snug fit but it will ...
200 questions posted
Usually answered in minutes!
214 Questions
154 Questions
124 Questions
98 Questions
94 Questions