1994 Nissan Pickup "midpoint locations" Questions

...Do this by locating the longest part of the belt not touching a pulley. Depress the belt at the midpoint of this open span with moderate thumb pressure. It should not deflect more than about 1/2 ...

...ok, engine does not spill hot wtr/overheat, gauge keeps registering hi then lowers but not pass the midpoint. Cant figure out what can be causing it to show hot, I can put hand on engine, no burn wtr ...

...such info, it would be gladly appreciated. Thanking you in anticipation. Kind regards Jim Whytock midpoint@worldonline.co.za That is not a safe modification, the chassis is by no means built for ...

...problem The 2008 Tiburon has two clips holding the glovebox in place, They are located near the midpoint of each side. Work your fingers behind the top lip of the glovebox, starting in the middle ...

...midpoint of its range, then connect the temperature cable to the geared arm on the blower motor wheel. Rotate the temperature control knob from maximum cold to maximum warm to verify proper range of ...

...to tightening the short bolt. Then tighten the long bolt. Check tension by pressing down on the midpoint along the longest span between pulleys. Belt should not deflect more than 1/2 to 3/4 inch. ...

How do you change a fuel filter The fuel filter is located on the left frame rail midpoint near the transmission crossover,relieveing fuel pressure on these can be a bit tough,what i do is put a drain

...and the water pump pulley. Push down on the belt and measure the distance between the belt at the midpoint and the straight edge. It should be between 1/2 and 1/4 inch. Any more and the belt needs ...

...with the ground. Now you should have a cross right above your center of the bulb7. Measure also the midpoint and put a small vertical tape there so that you mark the center of your vehicle.8.Measure ...

...dx The starter is located partially underneath the engeine in the center rear , right about at the midpoint of the cylanders anout 6- 12 down , its mostly hidden be the engiene itself, but you can ...