Question about Pontiac Bonneville
...Windshield Wipers And Washers Windshield Wiper Blade And Arm... Here's the second link showing you how to remove the wiper motor. Repair Guides Windshield Wipers And Washers Windshield Wiper
...wiper arm has a piece that covers the point where the arm connects to the motor. any suggestions? On your wiper switch you have a park position and on your wiper motor the same.It takes a little ...
wiper arm is a little balck cap, remove this cap and under it is a nut. this nut holds the wiper arm tight onto a spline. check to see if the nut has backed off or needs to be tightened. if not remove
...wiper arm to remove cowl Look carefully at the base of the wiper blace. At the base of the arm - where it fits onto the shaft - you will see a small moveable tab. Pull it out - it fits into a groove ...
Question about Pontiac Bonneville
how do you remove the wiper blade arm of a 1996 pontiac bonneville There is a small thin metal tab on the bottom of the arm. pull it up to disengage the arm as you pull up on the arm at the same time.
Question about Pontiac Bonneville
...wiper arm then completely sealing every seam on the motor flex-seal works just fine if you don't have silicone sealer let it cure and at least for me problem solved. I had previously lost 2 motors in ...
Question about Pontiac Bonneville
...this is a wiper motor probelm or perhaps a wiper arm probelm. All theroies are greatly appreicated. Thanks if you had your windshield replaced they may not have been put back on in the proper ...
wipers dont work! i have new motor in it of wipers and when i installed wipers only move about 4 inches up and then down with no strength i replaced the brackets too and wiper arms .basicly its all ...
1999 pontiac bonneville winshield wipers the winshield wipers work but the wont go all the way down. i replaced the wiper motor and still have the same problem Likely you don't have the blade arms ...
wipers want work,fuse is goood where is wiper motor HI, motor should be at the rear of the engine bay, if you can hear the motor running - sounds like the connecting arm as dropped off, good luck.
247 questions posted
Usually answered in minutes!
547 Questions
496 Questions
481 Questions
432 Questions
391 Questions