1993 Buick Century "crank shaft sensor 93" Questions

...have a weak crank shaft sensor.. I have had the same problem with my 93 century. The mechanic says it is the soleniod for the clutch/ torque converter. It has an automatic transmission. Hope this ...

crank shaft sensor for a 93 mercury sable Looking for location of the crank shaft sensor on a 93 Mercury Sable The 3.0 engine should be near the crank pulley in front of the engine. The 3.8 engine ...

circuit. changed cam shaft positioning sensor twice.still cranks did start once ran for 5 min. changed the sensor again. no luck. help please. keith Amazing!.. .did you take it in to have it diagnosed

...on a 93 Ford that it was bad and the coil wasnt getting any electricity while the switch was in "start" position. Most likely crank shaft position sensor. Or coil pack module, most likely crank ...

...no spark, replaced coil pack, crank shaft senser, cam shaft sensor, icu, ecm, hot to coil pack,fuel pressure good Check the fuel pump emergency cut off just in case also may want to look at the

...crank shaft sensor, if it has one. Any ideas? could be crank & cam sensor if they do not meet in sinc they will not get spark WILL THE CRANKSHAFT SENSOR AND IGNITION MODULE COME WITH THE ...

...crank shaft pulley. Check the wiring where it leaves the sensor and goes up near the alternator. On this year car its possible a small rock may have gotten thrown up from the road nd got into the ...

...dakota I damaged my flex plate turning it with a sfrew driver when I start it it idles bad what are ympyons Will it give crank shaft sensor bad reading shouldn't run at all with a damaged crank ...

...replaced, then water pump gave up, replaced.. now cranks but no start, what can we check? run fault codes and check the crank/cam position sensor. Check that the timing belt is driving the cam

...crank shaft sensor on a 93 chevy truck 1500 4.3 liter my 93 Chevy 1500 has no spark and no fuel from injectors. there is fuel to the TBI and engine turns over but will not start should be by the ...