...to lower timing chain cover 10nm (89in - lb) Loosening sequence is from oustside to inside crossover and tightning from inside to outside. check with a bmw dealer. its an old one. tough to find
Question about Pontiac Cars & Trucks
Timing chain cover torque specs for 2003 Pontiac Grand Am 3400 2003 Pontiac Grand Am 3400 timing chain cover torque specs needed The timing chain cover torque specs for a 2003 Pontiac Grand Am with ...
...spec. at the end but this is where if you tighten out of order something will break. pump assembly to timing chain housing nuts. pump cover to pump body bolts pump cover to cylinder block bolts ...
...timing chain. just need timing marks and head torque specs. ok Torque all bolts except No. 11 to 69 ft. lbs. on a cold engine or 75 ft. lbs. on a hot engine. Torque cylinder head to chain case cover ...
Question about Lincoln Cars & Trucks
...timing cover guides and valve covers I can give you the numbers for a 2009 3.5, dont have 07 service manuals. Probably the same. RH & LH valve cover is 89 in-lb. For bolts 17, 18. 19 & 20 the spec is ...
Question about Cars & Trucks
...spec for a 2003 jeep wrangler 2.4 connecting rods ENGINE 2.4L DESCRIPTION N·m Ft. Lbs. In. Lbs. Balance Shaft Carrier to Block-Bolts 54 40 - Balance Shaft Gear Cover-Double Ended Fastener 12 - 105 ...
...Timing chain front cover Oil pump WARNING Align all timing marks before performing the next step. Chain tensioner from the timing chain Cam sprockets NOTE: The timing chain remains in the chain case. ...
timing chain cover to access the water pump. The water pump is mounted to the engine block with 4 bolts. It is recommended that the bolts be replaced due to electrolysis (steel bolt in aluminum block)
Question about Cars & Trucks
...timing chain as well. You'll also need to remove the valve cover, then loosen the valve train and remove all of your head bolts(usually 8-10 per head) and don't forget to use new head bolts and ...
torque the push rod bolts. Rotate the engine until the V8 mark lines up with the TDC mark on the timing chain cover.Make sure the tips of the pushrods are lubricated then torque the bolts to 21 ft.lbs
184 questions posted
Usually answered in minutes!
690 Questions
526 Questions
285 Questions
276 Questions
230 Questions