Sony KDS-R60XBR1 60" Projection HDTV "replacing lamp driver" Questions

...Lamp Driver with a 1468798-16. The TV comes on, and I get a picture for about 30 seconds and then the picture/lamp goes out while the green light blinks. Then the picture/lamp comes back for about 30 ...

...lamp driver (ballast) problem. remove lamp and check the connections of the lamp driver and the lamp itself.Connections may look burned.if they do replace that part (lamp or lamp driver). If the lamp ...

...lamp driver or the lamp? If it does need the lamp driver, how do I replace it? Is there a manual? Any suggestions on where to purchase the parts? Thanks! 5 times blink code means Lamp Driver error ...

...replacing the lamp catridge. 5 red blinks happens when the tv goes into shutdown because the lamp driver doesnt turn on the lamp. sometimes the lamp driver or ballast can be the problem but the lamp ...

lamp driver error, which is possibly related to your lamp failure. You may have to replace the lamp driver or "ballast" to correct this problem. The 6 flash is a power supply problem and more serious,

...Lamp enable line at connector J14 pin 6 on the Engine Driver PCB switches to 5 volts after turn on but does not go back to 0-volts (low) after 5 seconds, 12 and 5 volt supplies are good. Suspect the ...

...lamp driver problem on a sony grand wega 50" tv? Could be lamp, driver bd., or both. Probably $250 for driver replacement. THE LAMP DRIVER COST IS ABOUT $125 plus labor marbe $350 , avery tv shop has ...

...cover snaps off, using screw driver open lamp door, unscrew lamp, pull out with handle, make sure lamp is cool. Replace, follow onscreen display to reset lamp hours. Use remote to enter

replacing again I just replaced it less then two years ago. My friend got the same TV at the same time and has never replaced the bulb ? can you go to the error menu? im assuming it's the lamp however

...lamp driver. Total bulb hours used 5698. Original factory installed bulb, never been replaced. Sony techs say it needs a new lamp or the power supply box needs to be replaced. I am also getting ...