Kenwood KAC-9152D Car Audio Amplifier "output negative" Questions

...the inputs not used on both subs. Adjust settings in amp and radio and if it doesn't sound good use negative and positive outputs from one single output (only left or only right) Hope this

...the inputs not used on both subs. Adjust settings in amp and radio and if it doesn't sound good use negative and positive outputs from one single output (only left or only right) Hope this ...

...in amp and radio and if it doesn't sound good use negative and positive outputs from one single output (only left or only right) Hope this helps http://www.hifisoundconnection.com has your ...

...of your other woofer and the negative goes to the negative output of the amp.If that amp is bridgeable this will give u a good bass and the impedance will be 8 ohm so your amp will run cool and ...

...output plug then find each wire and run to your new amp. Your basically bypassing old amp. your left front, red with white stripe is possitive. Brown is negative. Right front possitive is green. ...

...4 should be inputs positive left, negative left, positive right and negative right. Thee same for outputs. I is designed to connect in between yuri amp and the smaller satellite ...

...the positive spot on the opposite side of the amp. So you will have the negatives from one side's outputs (or channel 1) and the positives from the other side's outputs (channel 2). Thus, your amp ...

...4 channel amp 36401 be bridged on bchannel. and what would the ems be? You can bridge the speaker outputs; positive from channel two(2) , and negative from channel one (1) : Positive from channel ...

...you wiring is correct. Positive to positive and negative to negative. If it still blows fuses then Power supply or output rails are dead short. Take it in to a reputable dealer and have it

negative (-) terminal of the amps speaker output. Connect the positive probe of the DMM to the (+) terminal of the amps speaker output. The output terminals you are referencing should be the output to