Yamaha LPX500 Multimedia Projector "cinema filter" Questions

...Cinema filter. There is a pinion gear inside the motor housing that begins to slip and fails to move the filter. I have successfully pulled the gear and put loctite gel on the shaft where the pinion ...

cinema filter"msg Will only work in cinema dark mode, now and change to normal daytime modes result in this error message, do you know what is the best thing to do (is there a part I can buy etc) as I

The temperature sensor light is flashing on PowerLite Home Cinema 1080. How do I reset the temperature sensor without sending it to be reparied by an authorized Epson company. Fist thing you need to ...

...the filter system not working properly. Then on next startup there was no picture and the red light was blinking at 1 second interval. Epson home cinema 400 this means that an internal fault is ...

I hve epson home theatre cinema theatre, it showed an overheating message and it was the first time is it still ok to use? If you clean the filters and air ways, that should stop it from happening ...

permanent blue hue down one side of screen PT ae700 panasonic replaced lamp made no differance tried compressed air no change please help if the discoloration has a sharp pixelated edge, it may be the

...cinema and need to find an owners manual for it - especially to know if there is an air filter than needs to be cleaned, and if so how often and where it is located. I found this HP site, it may hold ...

...cinema filter is not changing position. This could be due to a connector problem, build up of dust around these devices etc. If you unplug the unit and take the cover off carefully, look around the ...

...cinema projector isn't lighting up My yamaha LPX 500 projector is turning on (green light comes on) then after a short time the system switches to red and turns off. I replaced the lamp about a year ...

...cinema projector model number hd66 the bulb keeps going off after a while of viewing any suggestions The bulb cutting out is usually down to it overheating. I thought it was a loose connection at ...