Goodman CKL42AR42 Air Conditioner "proper low side freon pressure" Questions

...low side gage should be what discharge air temp you are trying to obtain (50-55 degrees), and needle should indicate proper pressure for freon type. if both gages read higher than normal, could be an ...

suction 115.cant get low side to come up.need to know what should i be checking to figure out why. What freon are you using? Those are the proper operating pressures for R410A. What else is happening

...reversing valve. You cannot replace the coil with a remote sensing bulb on this unit. Usually you know when reversing valves get stuck when you are having low side problems with heat working ...

low pressure side (the bigger line going inside the vehicle). Be careful not to add too much or risk damaging the compressor. Keep the container right side up, so only gas and no liquid will enter the

...superheat by converting low side pressure into temperature and get the temperature of the low side line and subtract them to get your superheat reading. It must be 10 degrees F for proper

...low and therefore proper condensing does not take place causing the refrigerant to pool in the condenser and starving the evaporator. This causes a lower temperature in the evaporator resulting in ...

...low side of 80psi, and in the high side around 250, but in the high side it started increasing and it got to 400, and the unit was cutting off every 10 to 12 minutes. I would like it very much if ...

proper level of freon.Lets say it is 75 degrees outside and I added to where the low side reads around 30 and the high side is around 120-130.(orignal problem was inside freezing up.)The air is now ok

...proper gauges and pressure lines to attach to the compressor, to delivery the refrigerant gas. But, before you can do that, you must purge and capture any of the remaining Freon gas left in the ...

...low side, mighr be a schraeder valve or possibly around compressor. However whn charging freon both valves should be open or the freon will pump down in the condenser and the low side pressure will ...