...it doesn't appear to dry. It will then flash a fault code 81 (8 short flashes of the 'clean' light, pause, and then 1 more short flash of the 'clean' light, longer pause, and repeat the code). The ...
...Pause light turns on red and stays red 4.Unit beeps constantly until i turn off the switch that controls both dish drawers. I did notice that the pan that sits underneath the dish drawer when i pull ...
...pause, seven times, etc. ?? If so you may have a bad heater element. Or the water temp into the D/W is not hot enough. Most machines require at least 120 degree water to work properly. Take a close ...
...pause) when I open the door. It keeps running as if the door was still closed. Obviously this is annoying since I can't add a dish or whatever just after the cycle starts (without getting sprayed!). ...
work and when we turn turn the dishwasher on ti makes the beeping sounds but somehow the bottom dishwasher works fine. when we turn the top one on then after about a minute it stops and starts to make
dish washer 665.13824k601 clean light blinks 7 times pauses 1 second and repeats. will not work. the light above the clean cycle indicator blinks 7 times. I can not run the dishwasher, When I press ...
...dish washers before, this is potentialy a DIY job - the Haynes Dishwasher manual is very good, and parts can be found on the internet. The reason for cheking it is actually heating the water is that ...
Question about Haier Dishwashers
...pause the unit about 10 minutes into the wash cycle (hit the stop/start button) and feel the water in the bottom. It should be hot, not lukewarm. Also, if the heater isn't working, you won't see as ...
I have a Whirlpool dishwasher model GU400XTPQ3 and it stays on the clean cycle and will not advance despite saying it has 2 minutes left? Please help. Thank you! is there any error codes showing most ...
111 questions posted
Usually answered in minutes!
480 Questions
217 Questions
151 Questions
124 Questions
109 Questions