blender jar rotates but does not turn the cutting blades on the inside of the jar. Can this be fixed or do you have to replace the whole jar? look on ebay for a replacement second hand unit This means
...blender is put on top, the blade will not spin. your blade assembly is corroded. take it off, and using a rag, grab the blades. using another rag, grab the other end (probably rubber) and turn ...
working too hard, and blades do not turn. Devise turns when blender container is not on it. To take the blades off, grab the blades with a rag so you don't cut yourself, then grab the other end with a
...blender come on but the motor just stopped working Using your blade holder, turn the motor from the blade end. 1 or two turns. Tak the blade holder out, Plug in an test Sometimes the brushes in the ...
Question about Blenders
...working fine. The blades may not be turning because the blade assembly is not fully tightened onto the blender bottle. Another reason could be that you are not putting the blender bottle and blade ...
...be the shaft needs lubing, remove the bottom part of the blender blade... the rubber thing that engages on the motor. I started with WD-40 and worked some lithium grease into it. Spins like new
Question about Back to Basics Blenders
...blade assembly. If you put the blender on low without the cannister on top touch the gear on top of the unit and see if the gear slips or stops. Use a pencil or something..Not your finger. If it ...
...Depending on the age of your blender, a new blade assembly may be available. I would recommend calling Kitchenaid Customer Service for pricing. Their toll-free telephone number is: ...
...at once, the heat can corrode the bar and cause the blade to stop spinning. You can either disassemble the blade unit, or buy a new blade unit online. google blender parts and you can get one for ...
Question about KitchenAid Blenders
...blender jar. The coupling seems to easily turn without the jar. Then the blades neve turn, once fully assembled. Is there a fix-it-yourself solution? Thank you! It must be one of the clutches not ...
10 questions posted
Usually answered in minutes!
13 Questions
4 Questions
1 Questions