SOURCE: Front braking is lost after changing lever.
the abs module needs to be bled via the hd digital technician 2 software; sorry need to take it to a dealer; can't fully bleed the module w/o it and it may interfere w/ warranty issues later
SOURCE: my bike quit while riding home the other day.
start of breaking down of HT coil, if breaksdown while warm, leave for a while and start back up, it's HT coil, sounds like you should just carry on and see if it gets worse, then you'll know. unusual for a sudden complete breakdown so you shouldn't be stranded.
SOURCE: How to adjust front brake lever on '06 hd road king?
This is by design. When you have new pads on the bike and a rotor within limits the lever has very limited travel before engaging.
As these parts wear the position of which the lever engages changes. Unless you know that at the last brake pad change the caliper was "centered" this could account for the travel and will result in premature wear on the components.
JP
SOURCE: 2002 HD Dyna Super Glide front brake noise at low
If it sounds like "swish-swish" noise, that is nornal for your bike. HD changed the front brakes in the 90's and the result was better stopping performance but there is that darned swishing sound. Don't worry about it, mate, there's nothing wrong with your bike.
Now, if you start to hear squealing when you pull the lever, take the bike to a shop to have the brakes pads replaced. If you feel vibration when you apply the brakes, take it to a shop immediately and have them check the wheel spokes for tightness.
SOURCE: I just purchased a 2008 Street Glide and the brake
Make sure the brake master cylinder is positioned firmly back against the switch housing. Loosen the two bolts that hold the master cylinder onto the handlebars and slide it back against the switch as firmly as possible. If this does not correct the problem, you must replace the front brake switch inside the throttle/switch housing.
409 views
Usually answered in minutes!
×