20 Most Recent 2009 Genuine Scooter Roughhouse R50 Questions & Answers


Hi, Diablomaster for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Genuine, despair not, for a mere zero $ you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.google.com/search?q=Open+the+seat+Genuine+Scooter+Roughhouse+R50&tbm=isch&source=univ&sa=X&ved=2ahUKEwj0toOFgtzlAhWj2FkKHWxxB-MQsAR6BAgEEAE&biw=1440&bih=757
https://www.youtube.com/watch?v=mrfBqjDT5BI
http://www.epfguzzi.com/scooterpunks/manuals/index.html
https://www.scootertuning.ca/en/3005-genuine-roughhouse-50?gclid=EAIaIQobChMI58Pbz_nb5QIV04NaBR0gggKvEAAYASAAEgK5yPD_BwE
https://absolutelyscooters.net/pdf/CGEN_dawg_scooter_manual.pdf

2009 Genuine... | Answered on Nov 09, 2019


Hi, Mark and the usual suspects are:
1. A faulty diaphragm in a vacuum type fuel valve.
2. A stuck carburetor slide needle.
3. A stuck carburetor float.
4. The float level is too high.
5. The carburetor needle and seat are contaminated or worn out.
6. The intake valve is not seating properly, check compression.
7. Intake reversion due to faulty cam timing.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
http://www.modernbuddy.com/forum/topic27216.html
http://www.genuinescooters.com/roughhouse.html
http://www.epfguzzi.com/scooterpunks/manuals/index.html
https://www.scootertuning.ca/en/3005-genuine-roughhouse-50?gclid=EAIaIQobChMI58Pbz_nb5QIV04NaBR0gggKvEAAYASAAEgK5yPD_BwE
https://absolutelyscooters.net/pdf/CGEN_dawg_scooter_manual.pdf

2009 Genuine... | Answered on Nov 09, 2019


Hi, Daniellubian before testing any electrical component in the Turn Signal Light Circuit it is "IMPERATIVE" that you have a fully charged battery of 12.5 volts or more and be able to pass a proper "LOAD" test because your battery may have 12.5 volts or more but little or zero amps causing the battery to be faulty and must be replaced, "AGM" batteries fall into this category more so than lead-acid types, also before diagnosing any turn signal/running light/parking light issue make sure the bulb is good and the light fuse has continuity with a test light. If you have replaced your OEM lights with one or all LED lights you are going to need a load equalizer.
If no turn signals are working the cause could be a faulty turn signal module/flasher or the connector going to it, look for corroded, loose, or broken pins/sockets. Contact spray cleaner is great for removing corrosion.
If your turn signal comes on but takes several seconds before it starts flashing you may have dirty contacts in the turn signal switch/button, the switch needs to be opened up and cleaned also the flasher may be starting to fail. It should be noted that cold weather will only exacerbate the situation especially when temperatures drop down below freezing and the location of the component, turn signal switches on the handlebar are at the mercy of the oncoming freezing 70 mph wind and makes it hard for the contacts to do their job covered in frozen grease/grime
If all four turn signals flash at the same time like hazard lights even though you only pressed one turn signal button then you have a LED light in the circuit and need a load equalizer that can be purchased from any motorcycle parts supplier.
If your speedometer does not function properly it will have to be fixed first because your turn signal module gets the data from the speedometer for normal turn signal function.
If your front turn signals don't work use a test light to check for power and ground at the bulb socket, then start backtracking the wiring through every wire connector to the turn signal switch/button and check for continuity, go all the way back to the fuse if necessary to find the cause of the malfunction.
If your rear turn signals don't work check your rear fender wiring harness connector first, look for, corroded, broken, loose pins/sockets, power, and a good ground, the harness connector is usually located under the seat on the front of the rear fender then keep tracing the wiring look for obvious harness damage caused by the rear tire.
If you still can't find the malfunction backtrack from the rear fender wiring harness connector.
If one side does not work you could have a faulty turn signal switch or module check for continuity.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.scooterdynasty.com/turnsignalrearleftorrightfor50cc2-strokegenuineblackcatrh.aspx
https://www.reddit.com/r/scooters/comments/3osb58/options_for_genuine_roughhouse_r50_rear_turn/
http://www.epfguzzi.com/scooterpunks/manuals/index.html
https://www.scootertuning.ca/en/3005-genuine-roughhouse-50?gclid=EAIaIQobChMI58Pbz_nb5QIV04NaBR0gggKvEAAYASAAEgK5yPD_BwE
https://absolutelyscooters.net/pdf/CGEN_dawg_scooter_manual.pdf

2009 Genuine... | Answered on Nov 09, 2019


Hi, Anonymous for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Genuine, despair not, for a mere zero $ you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.ebay.com/b/Scooter-Parts-Accessories-for-Genuine-Scooter-Co-Roughhouse-50/84149/bn_51092610
https://www.youtube.com/watch?v=WXxZVYyd-Ek
http://www.epfguzzi.com/scooterpunks/manuals/index.html
https://www.scootertuning.ca/en/3005-genuine-roughhouse-50?gclid=EAIaIQobChMI58Pbz_nb5QIV04NaBR0gggKvEAAYASAAEgK5yPD_BwE
https://absolutelyscooters.net/pdf/CGEN_dawg_scooter_manual.pdf

2009 Genuine... | Answered on Nov 09, 2019


Hi, Anonymous for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Genuine, despair not, for a mere zero $ you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
http://www.modernbuddy.com/forum/topic23431.html
https://www.youtube.com/watch?v=w0o9FpqymZU
http://www.epfguzzi.com/scooterpunks/manuals/index.html
https://www.scootertuning.ca/en/3005-genuine-roughhouse-50?gclid=EAIaIQobChMI-sX4svfb5QIVoINaBR3lhQKcEAAYASAAEgI9gvD_BwE
https://absolutelyscooters.net/pdf/CGEN_dawg_scooter_manual.pdf

2009 Genuine... | Answered on Nov 09, 2019


Dot 4 synthetic.

2009 Genuine... | Answered on Apr 07, 2014


6.2 Oz per side (dry) and top up to 4.92" both sides with 20W fork oil.

Genuine... | Answered on Jun 17, 2019


it must not have one

Genuine... | Answered on Mar 06, 2019


i have no idea what you are working on here but i suspect power equ of some sort. your carbs inlet needle and seat are leaking fuel and thats how its gets in the oil.

Genuine... | Answered on Sep 11, 2017


Assuming you mean a Digitech GNX2 floor effects pedal, go to the Digitech site, search GNX2 and select support: Manuals

https://www.digitech.com/discontinued-products/GNX2-.html?dwvar_GNX2-_color=Grey-GLOBAL-Current&cgid=discontinued-products

The Re-Categorize link in FixYa is broken so I can't put it in a better category. If it is not a Digitech pedal, could you please Comment with the full make and model of what you are looking for.

Motorcycles | Answered 9 hours ago

Not finding what you are looking for?
2009 Genuine Scooter Roughhouse R50 Logo

9 questions posted

Ask a Question

Usually answered in minutes!

Top Genuine Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

5962 Answers

ANTISPAMMER

Level 3 Expert

33381 Answers

Are you a Genuine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

GV 650 SE Genuine

  • GV 650 SE Genuine

Most Popular Question

genuine roughhouse 50 brake fluid

  • Motorcycles
Loading...