2005 Acura RL fob code reset? - 2005 Acura RL

SOURCE: need to reset the key

It is a PAIN. You have to be very precise and have good timing. I had to repeat the whole thing about 4 times before it worked. As a side note, a great place to read EVERYTHING about your car is at rl.acurazine.com it is terrific.


• This system accepts up to two transmitters.
• Entering the programming mode cancels all learned
transmitter codes, so none of the previously
programmed transmitters will work. You must
reprogram all the transmitters once you're in the
programming mode.

1. Open the driver's door.

2. Push up the driver's door master power door lock to
the unlock position. Hold it there for the rest of this
procedure.

3. Insert the key in the ignition switch, then remove it.
Repeat this four more times within 10 seconds.
(Steps 3 and 4 must be completed within 10
seconds, or the system will exit the programming
mode.)

4. Insert the key in the ignition switch. Make sure the
power door locks cycle to indicate that the system
has entered programming mode.

5. Press the "LOCK" or "UNLOCK" button on the
transmitter. Make sure the power door locks (all
except the driver's door) cycle to indicate that the
transmitter has been accepted.

6. To program a second transmitter, press its "LOCK"
or "UNLOCK" button within 10 seconds.

7. Release the master power door lock switch to exit
the programming mode.

SOURCE: I need help reseting code

Hi, The easiest way yo reset the codes on any are would be to remove the negative battery cable for 15 seconds and then reconnect it. This will reset the codes.